[U-Boot] [PATCH V2 1/2] GPIO: Tegra2: add GPIO driver for Tegra2

[Tom Warren]

On Thu, Jun 2, 2011 at 2:34 PM, Wolfgang Denk <wd at denx.de> wrote:
> Dear Tom Warren,
>
> In message <BANLkTi=w1u7q+W-VKRYCq-wB50e7edFAdA at mail.gmail.com> you wrote:
>>
>> Let me double-check. IIRC, one (cmd_gpio) didn't apply since it was
>> from another SoC and didn't have the commands we use on Tegra, and the
>> other (where the driver should go) ended with Mike saying "i'm not
>> sure sweating the location of the driver is important", so I've left
>> it with the other GPIO drivers.
>
> What I'm referring to is the "lots of duplicated code" part.
Actually, if you do a kompare between cmd_gpio.c and tegra2_gpio.c,
there's virtually no 'duplicated' code, just 2 different
implementations of do_gpio, with different args and parsing of params,
etc.  I use info, port, input and output, and cmd_gpio uses input,
set, clear and toggle.  Since cmd_gpio.c isn't built, it's not
duplicating any code in the U-Boot binary, space-wise.  So there's no
advantage to using it instead of my own driver's cmd parser.

Note that the PCA953x GPIO driver also does it's own cmd parsing in
do_pca953x().

Tom

>
> Best regards,
>
> Wolfgang Denk
>
> --
> DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
> HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
> Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
> Computers are not intelligent. They only think they are.
>