[U-Boot] [PATCH v2 5/5] arm/km: add support for portl2 board

[Prafulla Wadaskar]

> -----Original Message-----
> From: Holger Brunck [mailto:holger.brunck at keymile.com]
> Sent: Wednesday, June 08, 2011 5:13 PM
> To: u-boot at lists.denx.de
> Cc: Valentin Longchamp; Holger Brunck; Prafulla Wadaskar; Heiko Schocher
> Subject: [PATCH v2 5/5] arm/km: add support for portl2 board
> 
> From: Valentin Longchamp <valentin.longchamp at keymile.com>
> 
> This adds support for the keymile Kirkwood BEC portl2 board. This board
> relies on the km_arm (km_kirkwood) BEC.
> 
> The egiga driver is configured for a 100M full-duplex, A/N off
> connnection
> to the backplane. This board has always ethernet present, because it is
> connected to the marvell switch similar to mgcoge3un. The reset_phy
> functionality is also the same to mgcoge3un.
> 
> Signed-off-by: Valentin Longchamp <valentin.longchamp at keymile.com>
> Signed-off-by: Holger Brunck <holger.brunck at keymile.com>
> cc: Prafulla Wadaskar <prafulla at marvell.com>
> cc: Heiko Schocher <hs at denx.de>
> ---
> Changes for v2:
>    - add this board support patch to the end of the serie
> 
>  MAINTAINERS                   |    1 +
>  MAKEALL                       |    1 +
>  board/keymile/km_arm/km_arm.c |    8 +++--
>  boards.cfg                    |    1 +
>  include/configs/portl2.h      |   81
> +++++++++++++++++++++++++++++++++++++++++
>  5 files changed, 89 insertions(+), 3 deletions(-)
>  create mode 100644 include/configs/portl2.h
> 

Applied to u-boot-marvell.git next branch
Regards..
Prafulla . .