[U-Boot] [PATCH 1/2] arm/kirkwood: if CONFIG_SOFT_I2C is set don't set CONFIG_I2C_MVTWSI

Prafulla Wadaskar prafulla at marvell.com
Wed Jun 15 09:21:01 CEST 2011



> -----Original Message-----
> From: Holger Brunck [mailto:holger.brunck at keymile.com]
> Sent: Tuesday, June 14, 2011 12:42 PM
> To: u-boot at lists.denx.de
> Cc: Holger Brunck; Valentin Longchamp; Prafulla Wadaskar; Heiko Schocher
> Subject: [PATCH 1/2] arm/kirkwood: if CONFIG_SOFT_I2C is set don't set
> CONFIG_I2C_MVTWSI
> 
> Some boards e.g. keymile arm boards have CONFIG_CMD_I2C switched on
> but they use soft i2c on kirkwood. So don't switch CONFIG_I2C_MVTWSI
> on in this case.
> 
> Signed-off-by: Holger Brunck <holger.brunck at keymile.com>
> cc: Valentin Longchamp <valentin.longchamp at keymile.com>
> cc: Prafulla Wadaskar <prafulla at marvell.com>
> cc: Heiko Schocher <hs at denx.de>
> ---
>  arch/arm/include/asm/arch-kirkwood/config.h |    2 ++
>  1 files changed, 2 insertions(+), 0 deletions(-)
> 
> diff --git a/arch/arm/include/asm/arch-kirkwood/config.h
> b/arch/arm/include/asm/arch-kirkwood/config.h
> index 71ba464..b7dae1e 100644
> --- a/arch/arm/include/asm/arch-kirkwood/config.h
> +++ b/arch/arm/include/asm/arch-kirkwood/config.h
> @@ -137,7 +137,9 @@
>   * I2C related stuff
>   */
>  #ifdef CONFIG_CMD_I2C
> +#ifndef CONFIG_SOFT_I2C
>  #define CONFIG_I2C_MVTWSI
> +#endif
>  #define CONFIG_SYS_I2C_SLAVE		0x0
>  #define CONFIG_SYS_I2C_SPEED		100000
>  #endif

Acked-By: Prafulla Wadaskar <Prafulla at marvell.com>

Regards..
Prafulla . .

> --
> 1.7.1



More information about the U-Boot mailing list