[U-Boot] [PATCH] phylib: Detect link on 10G devices correctly

Andy Fleming afleming at freescale.com
Thu May 19 01:44:19 CEST 2011


gen10g_startup() had 2 bugs:

1) It had a boolean logic error in checking the MMD mask, and
always checked all of them.

2) It checked devices which don't actually report link state, which
meant that it would never believe the link was fully up.

Fix the boolean logic, and then mask the MMD mask so only link-reporting
devices are checked.

Signed-off-by: Andy Fleming <afleming at freescale.com>
Reported-by: Ed Swarthout <Ed.Swarthout at freescale.com>
---

 drivers/net/phy/generic_10g.c |    8 ++++++--
 include/linux/mdio.h          |    8 ++++++++
 2 files changed, 14 insertions(+), 2 deletions(-)

diff --git a/drivers/net/phy/generic_10g.c b/drivers/net/phy/generic_10g.c
index 315c508..1c3e69e 100644
--- a/drivers/net/phy/generic_10g.c
+++ b/drivers/net/phy/generic_10g.c
@@ -36,7 +36,7 @@ int gen10g_shutdown(struct phy_device *phydev)
 int gen10g_startup(struct phy_device *phydev)
 {
 	int devad, reg;
-	u32 mmd_mask = phydev->mmds;
+	u32 mmd_mask = phydev->mmds & MDIO_DEVS_LINK;
 
 	phydev->link = 1;
 
@@ -44,8 +44,12 @@ int gen10g_startup(struct phy_device *phydev)
 	phydev->speed = SPEED_10000;
 	phydev->duplex = DUPLEX_FULL;
 
+	/*
+	 * Go through all the link-reporting devices, and make sure
+	 * they're all up and happy
+	 */
 	for (devad = 0; mmd_mask; devad++, mmd_mask = mmd_mask >> 1) {
-		if (!mmd_mask & 1)
+		if (!(mmd_mask & 1))
 			continue;
 
 		/* Read twice because link state is latched and a
diff --git a/include/linux/mdio.h b/include/linux/mdio.h
index 022d772..f2080dd 100644
--- a/include/linux/mdio.h
+++ b/include/linux/mdio.h
@@ -120,6 +120,14 @@
 #define MDIO_DEVS_VEND1			MDIO_DEVS_PRESENT(MDIO_MMD_VEND1)
 #define MDIO_DEVS_VEND2			MDIO_DEVS_PRESENT(MDIO_MMD_VEND2)
 
+#define MDIO_DEVS_LINK			(MDIO_DEVS_PMAPMD | \
+					MDIO_DEVS_WIS | \
+					MDIO_DEVS_PCS | \
+					MDIO_DEVS_PHYXS | \
+					MDIO_DEVS_DTEXS | \
+					MDIO_DEVS_AN)
+					
+
 
 /* Control register 2. */
 #define MDIO_PMA_CTRL2_TYPE		0x000f	/* PMA/PMD type selection */
-- 
1.6.5.2.g6ff9a




More information about the U-Boot mailing list