[U-Boot] [PATCH v3 01/12] OMAP3: Update SDRC dram_init to always call make_cs1_contiguous()

Tom Rini trini at ti.com
Wed Nov 9 18:10:55 CET 2011


We update the comment in make_cs1_contiguous() to be a little bit
more clear (it's been copy/pasted from other silicons) and then
explain in dram_init() why we need to always try this.

Note that in the previous behavior we were always calling this on
boards that never had cs1 populated anyhow so making sure we do
this always is fine and will correct things like omap3evm detecting
an invalid amount of memory (384MB).

Signed-off-by: Tom Rini <trini at ti.com>
---
 arch/arm/cpu/armv7/omap3/sdrc.c |   23 +++++++++++------------
 1 files changed, 11 insertions(+), 12 deletions(-)

diff --git a/arch/arm/cpu/armv7/omap3/sdrc.c b/arch/arm/cpu/armv7/omap3/sdrc.c
index 0dd1955..66ce33f 100644
--- a/arch/arm/cpu/armv7/omap3/sdrc.c
+++ b/arch/arm/cpu/armv7/omap3/sdrc.c
@@ -58,10 +58,9 @@ u32 is_mem_sdr(void)
 
 /*
  * make_cs1_contiguous -
- *  - For es2 and above remap cs1 behind cs0 to allow command line
- *    mem=xyz use all memory with out discontinuous support compiled in.
- *    Could do it at the ATAG, but there really is two banks...
- *  - Called as part of 2nd phase DDR init.
+ * - When we have CS1 populated we want to have it mapped after cs0 to allow
+ *   command line mem=xyz use all memory with out discontinuous support
+ *   compiled in.  We could do it in the ATAG, but there really is two banks...
  */
 void make_cs1_contiguous(void)
 {
@@ -207,16 +206,16 @@ int dram_init(void)
 
 	size0 = get_sdr_cs_size(CS0);
 	/*
-	 * If a second bank of DDR is attached to CS1 this is
-	 * where it can be started.  Early init code will init
-	 * memory on CS0.
+	 * We always need to have cs_cfg point at where the second
+	 * bank would be, if present.  Failure to do so can lead to
+	 * strange situations where memory isn't detected and
+	 * configured correctly.  CS0 will already have been setup
+	 * at this point.
 	 */
-	if ((sysinfo.mtype == DDR_COMBO) || (sysinfo.mtype == DDR_STACKED)) {
-		do_sdrc_init(CS1, NOT_EARLY);
-		make_cs1_contiguous();
+	make_cs1_contiguous();
+	do_sdrc_init(CS1, NOT_EARLY);
+	size1 = get_sdr_cs_size(CS1);
 
-		size1 = get_sdr_cs_size(CS1);
-	}
 	gd->ram_size = size0 + size1;
 
 	return 0;
-- 
1.7.0.4



More information about the U-Boot mailing list