[U-Boot] [PATCH 10/13] omap_gpmc: use SOFTECC in SPL if it's enabled
Ilya Yanok
yanok at emcraft.com
Fri Nov 11 01:39:45 CET 2011
Use software ECC for the SPL build if support for software ECC in SPL is
enabled.
Signed-off-by: Ilya Yanok <yanok at emcraft.com>
---
drivers/mtd/nand/omap_gpmc.c | 4 +++-
1 files changed, 3 insertions(+), 1 deletions(-)
diff --git a/drivers/mtd/nand/omap_gpmc.c b/drivers/mtd/nand/omap_gpmc.c
index 5bbec48..1dfe074 100644
--- a/drivers/mtd/nand/omap_gpmc.c
+++ b/drivers/mtd/nand/omap_gpmc.c
@@ -348,7 +348,7 @@ int board_nand_init(struct nand_chip *nand)
nand->chip_delay = 100;
/* Default ECC mode */
-#ifndef CONFIG_SPL_BUILD
+#if !defined(CONFIG_SPL_BUILD) || defined(CONFIG_SPL_NAND_SOFTECC)
nand->ecc.mode = NAND_ECC_SOFT;
#else
nand->ecc.mode = NAND_ECC_HW;
@@ -359,7 +359,9 @@ int board_nand_init(struct nand_chip *nand)
nand->ecc.correct = omap_correct_data;
nand->ecc.calculate = omap_calculate_ecc;
omap_hwecc_init(nand);
+#endif
+#ifdef CONFIG_SPL_BUILD
if (nand->options & NAND_BUSWIDTH_16)
nand->read_buf = nand_read_buf16;
else
--
1.7.6.4
More information about the U-Boot
mailing list