[U-Boot] [PATCH] Improve Power Management in SMC911X driver.

Igor Grinberg grinberg at compulab.co.il
Mon Nov 14 12:00:50 CET 2011


Hi Bertrand,

On 11/14/11 10:38, bertrand.cachet at heig-vd.ch wrote:
> From: Bertrand Cachet <bertrand.cachet at heig-vd.ch>
> 
>>From datasheet, when READY bit is set inside PM_CTRL register, it means that
> device is already in *normal* (D0) mode => it doesn't need to be wake-up.
> 
> With this patch, we only wake-up (writing on TEST_BYTE register) if PM_MODE
> bits of PM_CTRL register is in D1/D2 mode.
> 
> Signed-off-by: Bertrand Cachet <bertrand.cachet at heig-vd.ch>
> ---
>  drivers/net/smc911x.h |    6 ++++--
>  1 files changed, 4 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/net/smc911x.h b/drivers/net/smc911x.h
> index 8ce08a9..258b9b6 100644
> --- a/drivers/net/smc911x.h
> +++ b/drivers/net/smc911x.h
> @@ -471,8 +471,10 @@ static void smc911x_reset(struct eth_device *dev)
>  {
>  	int timeout;
>  
> -	/* Take out of PM setting first */
> -	if (smc911x_reg_read(dev, PMT_CTRL) & PMT_CTRL_READY) {
> +	/*  Take out of PM setting first */
> +  /*  If PMT_CTRL_READY bit is set to 1b => power management is 
> +      already ready */

The multi-line comments should look like this:
/*
 * blablabla
 */

> +	if ((smc911x_reg_read(dev, PMT_CTRL) & PMT_CTRL_READY) == 0) {
>  		/* Write to the bytetest will take out of powerdown */
>  		smc911x_reg_write(dev, BYTE_TEST, 0x0);
>  

-- 
Regards,
Igor.


More information about the U-Boot mailing list