[U-Boot] [PATCH 1/5] mx53loco: Configure the pins as GPIOs prior to using gpio_get_value

Stefano Babic sbabic at denx.de
Thu Nov 17 07:39:01 CET 2011


On 11/15/2011 04:51 PM, Fabio Estevam wrote:
> Configure the pins as GPIO prior to using gpio_get_value.
>
> Cc: Jason Liu<r64343 at freescale.com>
> Signed-off-by: Fabio Estevam<fabio.estevam at freescale.com>
> ---
>   board/freescale/mx53loco/mx53loco.c |    3 +++
>   1 files changed, 3 insertions(+), 0 deletions(-)
>

Applied to u-boot-imx, thanks

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================


More information about the U-Boot mailing list