[U-Boot] [PATCH v4 0/3] mpc85xx: support for Freescale COM Express P2020

[Ira W. Snyder]

This is a cleaned up version of the U-Boot port provided with the BSP for
the Freescale COM Express P2020 evaluation kit.

This board is booted from SD card or SPI flash by using the Freescale
On-Chip ROM to load U-Boot into L2 SRAM. U-Boot configures and initializes
the DDR SDRAM using the SPD on the module.

The SPD on the 2GB DDR3 DIMM shipped with this evaluation kit has an
invalid value (0x08) in the module_type field (eeprom address 0x03).
Therefore, a workaround patch was added to the SPD decoder to assume an
unregistered DIMM in this case. Other suggestions are welcome.

Changes v3 -> v4:
- address review comments
- boot via L2 SRAM (just like P2020DS)
- use SPD EEPROM to configure DDR SDRAM

Changes v2 -> v3:
- re-enable CCSR relocation

Changes v1 -> v2:
- fix checkpatch warnings
- remove references to NAND (this board lacks NAND)
- disable CCSR relocation

Ira W. Snyder (3):
  mpc85xx: support board-specific reset function
  mpc8xxx: assume unregistered DIMM for invalid SPD module_type
  mpc85xx: support for Freescale COM Express P2020

 MAINTAINERS                                     |    4 +
 arch/powerpc/cpu/mpc85xx/cpu.c                  |   17 +-
 arch/powerpc/cpu/mpc8xxx/ddr/ddr3_dimm_params.c |    7 +-
 arch/powerpc/include/asm/immap_85xx.h           |    1 +
 board/freescale/p2020come/Makefile              |   46 ++
 board/freescale/p2020come/ddr.c                 |   45 ++
 board/freescale/p2020come/law.c                 |   39 ++
 board/freescale/p2020come/p2020come.c           |  287 +++++++++++
 board/freescale/p2020come/tlb.c                 |   99 ++++
 boards.cfg                                      |    2 +
 include/configs/P2020COME.h                     |  576 +++++++++++++++++++++++
 11 files changed, 1118 insertions(+), 5 deletions(-)
 create mode 100644 board/freescale/p2020come/Makefile
 create mode 100644 board/freescale/p2020come/ddr.c
 create mode 100644 board/freescale/p2020come/law.c
 create mode 100644 board/freescale/p2020come/p2020come.c
 create mode 100644 board/freescale/p2020come/tlb.c
 create mode 100644 include/configs/P2020COME.h

-- 
1.7.3.4