[U-Boot] [PATCH 1/2] ARM: omap3: added common configuration for Technexion TAM3517

[Stefano Babic]

On 23/11/2011 13:44, Igor Grinberg wrote:
> Hi Stefano,

Hi Igor,

>> +/*
>> + * NS16550 Configuration
>> + */
>> +#define V_NS16550_CLK			48000000	/* 48MHz (APLL96/2) */
>> +
>> +#define CONFIG_SYS_NS16550
>> +#define CONFIG_SYS_NS16550_SERIAL
>> +#define CONFIG_SYS_NS16550_REG_SIZE	(-4)
>> +#define CONFIG_SYS_NS16550_CLK		V_NS16550_CLK
> 
> Can this be inlined? instead of defining the define...

Yes, I will do it.

>> +#define CONFIG_OMAP_EHCI_PHY1_RESET	25
> 
> The latest patch from Ilya makes it:
> CONFIG_OMAP_EHCI_PHY1_RESET_GPIO

Ok, thanks, I will fix it.

>> +
>> +#define CONFIG_JFFS2_NAND
>> +/* nand device jffs2 lives on */
>> +#define CONFIG_JFFS2_DEV		"nand0"
>> +/* start of jffs2 partition */
>> +#define CONFIG_JFFS2_PART_OFFSET	0x680000
>> +#define CONFIG_JFFS2_PART_SIZE		0xf980000	/* sz of jffs2 part */
> 
> Can SZ_* defines from arch/arm/include/asm/sizes.h be used here?

I will drop the JFFS2 at all. If a JFFS2 is required, this should be not
put in this common file, but in the board specific file.

>> +#ifdef CONFIG_USE_IRQ
>> +#define CONFIG_STACKSIZE_IRQ	(4 << 10)	/* IRQ stack 4 KiB */
>> +#define CONFIG_STACKSIZE_FIQ	(4 << 10)	/* FIQ stack 4 KiB */
>> +#endif
> 
> These can be removed, as already done in a recent patch from Thomas:
> http://patchwork.ozlabs.org/patch/127087/

Thanks, I will do it.

>> +/* SDRAM Bank Allocation method */
>> +/* TODO : Check */
>> +/* #define SDRC_R_B_C		1 */
> 
> This is also, removed by a patch from Thomas:
> http://patchwork.ozlabs.org/patch/127145/

Ok !

>> +#define CONFIG_MII
>> +#define CONFIG_EMAC_MDIO_PHY_NUM	0
>> +#define	CONFIG_BOOTP_DEFAULT
> 
> Can this be aligned with all the others?

Yes, of course.

>> +#define CONFIG_SYS_NAND_ECCTOTAL       (CONFIG_SYS_NAND_ECCBYTES * \
>> +						CONFIG_SYS_NAND_ECCSTEPS)
>> +
>> +#define CONFIG_SYS_NAND_U_BOOT_START   CONFIG_SYS_TEXT_BASE
> 
> Here (and in some more places) you have spaces for alignment.

I will recheck, thanks.

best regards,
Stefano babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================