[U-Boot] [PATCH 06/12] Davinci: ea20: add gpio for keeping power on in board_late_init

[Stefano Babic]

From: Bastian Ruppert <Bastian.Ruppert at Sewerin.de>

The pin called HALTEN drives a transistor to operate the supply
voltage. After HALTEN is high, the user can release the power
switch button and the device will stay powered on.

Signed-off-by: Bastian Ruppert <Bastian.Ruppert at Sewerin.de>
CC: sbabic at denx.de
CC: dzu at denx.de
---
 board/davinci/ea20/ea20.c |   25 +++++++++++++++++++++++++
 include/configs/ea20.h    |    1 +
 2 files changed, 26 insertions(+), 0 deletions(-)

diff --git a/board/davinci/ea20/ea20.c b/board/davinci/ea20/ea20.c
index da9086a..1a57baf 100644
--- a/board/davinci/ea20/ea20.c
+++ b/board/davinci/ea20/ea20.c
@@ -98,6 +98,10 @@ const struct pinmux_config gpio_pins[] = {
 	{ pinmux(13), 8, 3 }  /* GPIO6[12] U0_SW1 on EA20-00101_2*/
 };
 
+const struct pinmux_config halten_pin[] = {
+	{ pinmux(3),  4, 2 } /* GPIO8[6] HALTEN */
+};
+
 static const struct pinmux_resource pinmuxes[] = {
 #ifdef CONFIG_SPI_FLASH
 	PINMUX_ITEM(spi1_pins),
@@ -205,6 +209,27 @@ int board_init(void)
 
 	return 0;
 }
+
+#ifdef BOARD_LATE_INIT
+
+int board_late_init(void)
+{
+	struct davinci_gpio *gpio8_base =
+			(struct davinci_gpio *)DAVINCI_GPIO_BANK8;
+
+	/* PinMux for HALTEN */
+	if (davinci_configure_pin_mux(halten_pin, ARRAY_SIZE(halten_pin)) != 0)
+		return 1;
+
+	/* Set HALTEN to high */
+	writel((readl(&gpio8_base->set_data) | (1 << 6)),
+		&gpio8_base->set_data);
+	writel((readl(&gpio8_base->dir) & ~(1 << 6)), &gpio8_base->dir);
+
+	return 0;
+}
+#endif /* BOARD_LATE_INIT */
+
 #ifdef CONFIG_DRIVER_TI_EMAC
 
 /*
diff --git a/include/configs/ea20.h b/include/configs/ea20.h
index 7e0d833..7c9e4da 100644
--- a/include/configs/ea20.h
+++ b/include/configs/ea20.h
@@ -31,6 +31,7 @@
 #define	CONFIG_SYS_USE_NAND
 #define CONFIG_DRIVER_TI_EMAC_USE_RMII
 #define CONFIG_BOARD_EARLY_INIT_F
+#define BOARD_LATE_INIT
 
 /*
  * SoC Configuration
-- 
1.7.1