[U-Boot] [PATCH 02/12] Davinci: ea20: set GPIOs to hold MII-Phy in reset and set UART0-Switch for console

Laurence Withers lwithers at guralp.com
Wed Oct 5 14:06:42 CEST 2011


On Wed, Oct 05, 2011 at 11:43:29AM +0200, Stefano Babic wrote:
> From: Bastian Ruppert <Bastian.Ruppert at Sewerin.de>
> 
> Signed-off-by: Bastian Ruppert <Bastian.Ruppert at Sewerin.de>
> Signed-off-by: Stefano Babic <sbabic at denx.de>
> CC: dzu at denx.de
> CC: Sandeep Paulraj <s-paulraj at ti.com>
> ---
>  arch/arm/include/asm/arch-davinci/hardware.h |    4 +++
>  board/davinci/ea20/ea20.c                    |   30 +++++++++++++++++++++++++-
>  2 files changed, 33 insertions(+), 1 deletions(-)

There are generic GPIO functions (asm/gpio.h) for DaVinci; you should
probably use those instead of directly programming the registers.

Bye for now,
-- 
Laurence Withers, <lwithers at guralp.com>                http://www.guralp.com/
Direct tel:+447753988197 or tel:+443333408643               Software Engineer
General support queries: <support at guralp.com>         CMG-DCM CMG-EAM CMG-NAM


More information about the U-Boot mailing list