[U-Boot] [PATCH 3/3] qong: remove unneeded IOMUX settings

[Fabio Estevam]

On qong board some of the USBH2 pins are set via GPR register, so don need to setup
the IOMUX for each pin individually.

Other than that, these pins should not be configured as primary function because the primary
function selects SSI functionality.

Let GPR register do the work and remove the unneeded IOMUX setup.

Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>
---

Stefano,

I don't have access to the qong board to test this, but I believe this is the right thing to do here.

 board/davedenx/qong/qong.c |    6 ------
 1 files changed, 0 insertions(+), 6 deletions(-)

diff --git a/board/davedenx/qong/qong.c b/board/davedenx/qong/qong.c
index de32fb5..70af593 100644
--- a/board/davedenx/qong/qong.c
+++ b/board/davedenx/qong/qong.c
@@ -120,12 +120,6 @@ int board_early_init_f(void)
 	mx31_gpio_mux(IOMUX_MODE(MUX_CTL_USBH2_STP, MUX_CTL_FUNC));
 	mx31_gpio_mux(IOMUX_MODE(MUX_CTL_USBH2_DATA0, MUX_CTL_FUNC));
 	mx31_gpio_mux(IOMUX_MODE(MUX_CTL_USBH2_DATA1, MUX_CTL_FUNC));
-	mx31_gpio_mux(IOMUX_MODE(MUX_CTL_STXD3, MUX_CTL_FUNC));
-	mx31_gpio_mux(IOMUX_MODE(MUX_CTL_SRXD3, MUX_CTL_FUNC));
-	mx31_gpio_mux(IOMUX_MODE(MUX_CTL_SCK3, MUX_CTL_FUNC));
-	mx31_gpio_mux(IOMUX_MODE(MUX_CTL_SFS3, MUX_CTL_FUNC));
-	mx31_gpio_mux(IOMUX_MODE(MUX_CTL_STXD6, MUX_CTL_FUNC));
-	mx31_gpio_mux(IOMUX_MODE(MUX_CTL_SRXD6, MUX_CTL_FUNC));
 
 #define H2_PAD_CFG (PAD_CTL_DRV_MAX | PAD_CTL_SRE_FAST | PAD_CTL_HYS_CMOS | \
 			PAD_CTL_ODE_CMOS | PAD_CTL_100K_PU)
-- 
1.7.1