[U-Boot] [PATCH v4 03/11] net, davinci_emac: make clock divider in MDIO control register configurable
Heiko Schocher
hs at denx.de
Mon Oct 24 09:38:25 CEST 2011
Define CONFIG_SYS_EMAC_TI_CLKDIV for setting the clkdiv value
in the MDIO control register.
Signed-off-by: Heiko Schocher <hs at denx.de>
cc: Sandeep Paulraj <s-paulraj at ti.com>
cc: Wolfgang Denk <wd at denx.de>
---
drivers/net/davinci_emac.c | 9 +++++++--
1 files changed, 7 insertions(+), 2 deletions(-)
diff --git a/drivers/net/davinci_emac.c b/drivers/net/davinci_emac.c
index a8905b8..299f1e1 100644
--- a/drivers/net/davinci_emac.c
+++ b/drivers/net/davinci_emac.c
@@ -53,6 +53,11 @@ unsigned int emac_dbg = 0;
#define emac_gigabit_enable() /* no gigabit to enable */
#endif
+#if !defined(CONFIG_SYS_EMAC_TI_CLKDIV)
+#define CONFIG_SYS_EMAC_TI_CLKDIV ((EMAC_MDIO_BUS_FREQ / \
+ EMAC_MDIO_CLOCK_FREQ) - 1)
+#endif
+
static void davinci_eth_mdio_enable(void);
static int gen_init_phy(int phy_addr);
@@ -126,7 +131,7 @@ static void davinci_eth_mdio_enable(void)
{
u_int32_t clkdiv;
- clkdiv = (EMAC_MDIO_BUS_FREQ / EMAC_MDIO_CLOCK_FREQ) - 1;
+ clkdiv = CONFIG_SYS_EMAC_TI_CLKDIV;
writel((clkdiv & 0xff) |
MDIO_CONTROL_ENABLE |
@@ -427,7 +432,7 @@ static int davinci_eth_open(struct eth_device *dev, bd_t *bis)
#endif
/* Init MDIO & get link state */
- clkdiv = (EMAC_MDIO_BUS_FREQ / EMAC_MDIO_CLOCK_FREQ) - 1;
+ clkdiv = CONFIG_SYS_EMAC_TI_CLKDIV;
writel((clkdiv & 0xff) | MDIO_CONTROL_ENABLE | MDIO_CONTROL_FAULT,
&adap_mdio->CONTROL);
--
1.7.6.4
More information about the U-Boot
mailing list