[U-Boot] [PATCH v4 5/7] ARM: OMAP5-uevm: Add USB MAC ethernet address

[Dan Murphy]

Set the usbethaddr based on the OMAP DIE_ID registers
which should be unique for each processor.

Then set this as the usb ethernet MAC address.

Signed-off-by: Dan Murphy <dmurphy at ti.com>
---

v3 - new patch
v4 - Updated per the comments - http://patchwork.ozlabs.org/patch/259754/

 board/ti/omap5_uevm/evm.c |   23 +++++++++++++++++++++++
 1 file changed, 23 insertions(+)

diff --git a/board/ti/omap5_uevm/evm.c b/board/ti/omap5_uevm/evm.c
index 6219770..19d6e71 100644
--- a/board/ti/omap5_uevm/evm.c
+++ b/board/ti/omap5_uevm/evm.c
@@ -18,6 +18,10 @@
 #include <asm/arch/clock.h>
 #include <asm/arch/ehci.h>
 #include <asm/ehci-omap.h>
+
+#define DIE_ID_REG_BASE     (OMAP54XX_L4_CORE_BASE + 0x2000)
+#define DIE_ID_REG_OFFSET	0x200
+
 #endif
 
 DECLARE_GLOBAL_DATA_PTR;
@@ -122,9 +126,28 @@ int ehci_hcd_init(int index, struct ehci_hccr **hccr, struct ehci_hcor **hcor)
 {
 	int ret;
 	int auxclk;
+	int reg;
+	uint8_t device_mac[6];
 
 	enable_host_clocks();
 
+	if (!getenv("usbethaddr")) {
+		reg = DIE_ID_REG_BASE + DIE_ID_REG_OFFSET;
+
+		/*
+		 * create a fake MAC address from the processor ID code.
+		 * first byte is 0x02 to signify locally administered.
+		 */
+		device_mac[0] = 0x02;
+		device_mac[1] = readl(reg + 0x10) & 0xff;
+		device_mac[2] = readl(reg + 0xC) & 0xff;
+		device_mac[3] = readl(reg + 0x8) & 0xff;
+		device_mac[4] = readl(reg) & 0xff;
+		device_mac[5] = (readl(reg) >> 8) & 0xff;
+
+		eth_setenv_enetaddr("usbethaddr", device_mac);
+	}
+
 	auxclk = readl((*prcm)->scrm_auxclk1);
 	/* Request auxilary clock */
 	auxclk |= AUXCLK_ENABLE_MASK;
-- 
1.7.9.5