[U-Boot] [PATCH 2/3] spi: fsl_espi: Use DIV_ROUND_UP instead of open-coded

[Jagan Teki]

On 12-07-2013 15:11, Axel Lin wrote:
> Use DIV_ROUND_UP to simplify the code.
>
> Signed-off-by: Axel Lin <axel.lin at ingics.com>
> ---
>   drivers/spi/fsl_espi.c | 6 ++----
>   1 file changed, 2 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/spi/fsl_espi.c b/drivers/spi/fsl_espi.c
> index 28609ee..e20ab9f 100644
> --- a/drivers/spi/fsl_espi.c
> +++ b/drivers/spi/fsl_espi.c
> @@ -234,15 +234,13 @@ int spi_xfer(struct spi_slave *slave, unsigned int bitlen, const void *data_out,
>   	      slave->bus, slave->cs, *(uint *) dout,
>   	      dout, *(uint *) din, din, len);
>
> -	num_chunks = data_len / max_tran_len +
> -		(data_len % max_tran_len ? 1 : 0);
> +	num_chunks = DIV_ROUND_UP(data_len, max_tran_len);
>   	while (num_chunks--) {
>   		if (data_in)
>   			din = buffer + rx_offset;
>   		dout = buffer;
>   		tran_len = min(data_len , max_tran_len);
> -		num_blks = (tran_len + cmd_len) / 4 +
> -			((tran_len + cmd_len) % 4 ? 1 : 0);
> +		num_blks = DIV_ROUND_UP(tran_len + cmd_len, 4);
>   		num_bytes = (tran_len + cmd_len) % 4;
>   		fsl->data_len = tran_len + cmd_len;
>   		spi_cs_activate(slave);
>

Reviewed-by: Jagannadha Sutradharudu Teki <jagannadh.teki at gmail.com>

--
Thanks,
Jagan.