[U-Boot] [PATCH v2] Add NanoBone board support

Mark Jackson mpfj-list at newflow.co.uk
Sun Aug 11 10:31:00 CEST 2013


On 22/04/13 13:46, Mark Jackson wrote:
> NanoBone Specification:
> -----------------------
> CPU:
>   TI AM335x
> 
> Memory:
>   256MB DDR3
>   64MB NOR flash
>   256MB NAND flash
>   128KB FRAM
> 
> Ethernet:
>   2 x 10/100 connected to SMSC LAN8710 PHY
> 
> USB:
>   1 x USB2.0 Type A
> 
> I2C:
>   2Kbit EEPROM (Microchip 24AA02)
>   RTC (Maxim DS1338)
>   GPIO Expander (Microchip MCP23017)
> 
> Expansion connector:
>   6 x UART
>   1 x MMC/SD
>   1 x USB2.0
> 
> Signed-off-by: Mark Jackson <mpfj at newflow.co.uk>
> ---
> Changes in v2:
> - Tweaked after comments from Tom Rini
> 
>  MAINTAINERS                     |    4 +
>  board/newflow/nanobone/Makefile |   46 ++++++
>  board/newflow/nanobone/board.c  |  304
> +++++++++++++++++++++++++++++++++++++++
>  board/newflow/nanobone/board.h  |   24 ++++
>  board/newflow/nanobone/mux.c    |  203 ++++++++++++++++++++++++++
>  boards.cfg                      |    1 +
>  include/configs/nanobone.h      |  285 ++++++++++++++++++++++++++++++++++++
>  7 files changed, 867 insertions(+)
>  create mode 100644 board/newflow/nanobone/Makefile
>  create mode 100644 board/newflow/nanobone/board.c
>  create mode 100644 board/newflow/nanobone/board.h
>  create mode 100644 board/newflow/nanobone/mux.c
>  create mode 100644 include/configs/nanobone.h

Any chance this board can be added ?

Regards
Mark J.



More information about the U-Boot mailing list