[U-Boot] [PATCH] fec_mxc: set ethaddr if fuses burned and not previously set

Stefano Babic sbabic at denx.de
Wed Aug 21 13:19:27 CEST 2013


Hi Eric,

On 02/08/2013 19:37, Eric Nelson wrote:
> Without this change, the following message is generated:
> 	Warning: FEC using MAC address from net device
> 
> See doc/README.enetaddr for details.
> 
> Signed-off-by: Eric Nelson <eric.nelson at boundarydevices.com>
> ---
>  drivers/net/fec_mxc.c | 2 ++
>  1 file changed, 2 insertions(+)
> 
> diff --git a/drivers/net/fec_mxc.c b/drivers/net/fec_mxc.c
> index e14a359..886be9c 100644
> --- a/drivers/net/fec_mxc.c
> +++ b/drivers/net/fec_mxc.c
> @@ -980,6 +980,8 @@ static int fec_probe(bd_t *bd, int dev_id, uint32_t base_addr,
>  	if (fec_get_hwaddr(edev, dev_id, ethaddr) == 0) {
>  		debug("got MAC%d address from fuse: %pM\n", dev_id, ethaddr);
>  		memcpy(edev->enetaddr, ethaddr, 6);
> +		if (!getenv("ethaddr"))
> +			eth_setenv_enetaddr("ethaddr",mac);
                                                       ^--
of course, this should be ethaddr and not mac. I fixed it myself.

Best regards,
Stefano



-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================


More information about the U-Boot mailing list