[U-Boot] [RFC PATCH] Add support for Boundary Devices Nitrogen6x boards

[Benoît Thébaudeau]

Hi Eric,

On Wednesday, January 30, 2013 7:10:52 PM, Eric Nelson wrote:
> This patch adds support for the Nitrogen6X board(s) from
> Boundary Devices. The boards are based on the i.MX6x
> processor family with two major variants:
> 	i.MX6Quad/6Dual
> 	i.MX6Dual-Lite/6Solo
> 
> More specifically, the board variations are:
>        nitrogen6q              i.MX6Q/6D       1GB
>        nitrogen6dl             i.MX6DL         1GB
>        nitrogen6s              i.MX6S          512MB
>        nitrogen6q2g            i.MX6Q/6D       2GB
>        nitrogen6dl2g           i.MX6DL         2GB
>        nitrogen6s1g            i.MX6S          1GB
> 
> Refer to http://boundarydevices.com/products/ for details.
> 
> Signed-off-by: Eric Nelson <eric.nelson at boundarydevices.com>

You have probably already noticed it, but just to make sure you do not miss it,
my series about the i.MX6Q DDR3 init also affects this patch. And for the 6DL
and 6S variants, there is an equivalent change to make, translated to 400 MHz
(DDR3-800).

After a quick look at this patch, it looks good.

Best regards,
Benoît