[U-Boot] [RFC PATCH] Add support for Boundary Devices Nitrogen6x boards

[Eric Nelson]

Thanks for the review, Stefano.

On 02/12/2013 02:12 AM, Stefano Babic wrote:
> On 30/01/2013 19:10, Eric Nelson wrote:
>> This patch adds support for the Nitrogen6X board(s) from
>> Boundary Devices. The boards are based on the i.MX6x
>> processor family with two major variants:	
>> 	i.MX6Quad/6Dual
>> 	i.MX6Dual-Lite/6Solo
>>
>> More specifically, the board variations are:
>>         nitrogen6q              i.MX6Q/6D       1GB
>>         nitrogen6dl             i.MX6DL         1GB
>>         nitrogen6s              i.MX6S          512MB
>>         nitrogen6q2g            i.MX6Q/6D       2GB
>>         nitrogen6dl2g           i.MX6DL         2GB
>>         nitrogen6s1g            i.MX6S          1GB
>>
>> Refer to http://boundarydevices.com/products/ for details.
>
> Hi Eric,
>
> some general comments in praparation your V2. I have only some minor points.
>
> - Try to split your patch in several patches, if possible. The patch
> covers different issues and the series will be easy to be review. This
> is mainly for the changes outside boards/boundary - I know it is not
> easy to split the rest.
>
Understood. I submitted this as one big patch to show things
in context.

> - I agree you put your script in the board directory instead opf trying
> to use CONFIG_EXTRA_ENV_SETTINGS.
>
Cool.

> - Agree with the split of the configuration data (clocks.cfg and ddr
> setup). The same mechanism can be reused for other boards, too.
>

Thanks. Note that there's a bit of hand-waving for things that
don't quite fit, but the essential differences in memory setup
are properly partitioned.

> - and agree with the nomenclature. My +1 to rename mx6x_pins.h to
> mx6q_pins.h as you suggest in the cover letter.
>
Will do. I'll submit that before V2 of Nitrogen6X support so
it can be discussed separately.

Regards,


Eric