[U-Boot] [PATCH] EXYNOS: Correct ordering of SPL machine_params

[Rajeshwari Shinde]

From: Simon Glass <sjg at chromium.org>

The mem_manuf is not in the correct order according to the string table.
This causes cros_bundle_firmware to get the BL2 settings in the wrong
order. This patch fixes the same.

Signed-off-by: Simon Glass <sjg at chromium.org>
Signed-off-by: Rajeshwari Shinde <rajeshwari.s at samsung.com>
---
 arch/arm/include/asm/arch-exynos/spl.h |    3 ++-
 1 files changed, 2 insertions(+), 1 deletions(-)

diff --git a/arch/arm/include/asm/arch-exynos/spl.h b/arch/arm/include/asm/arch-exynos/spl.h
index 306b41d..46b25a6 100644
--- a/arch/arm/include/asm/arch-exynos/spl.h
+++ b/arch/arm/include/asm/arch-exynos/spl.h
@@ -78,11 +78,12 @@ struct spl_machine_param {
 	 */
 	u32		uboot_size;
 	enum boot_mode	boot_source;	/* Boot device */
-	enum mem_manuf	mem_manuf;	/* Memory Manufacturer */
 	unsigned	frequency_mhz;	/* Frequency of memory in MHz */
 	unsigned	arm_freq_mhz;	/* ARM Frequency in MHz */
 	u32		serial_base;	/* Serial base address */
 	u32		i2c_base;	/* i2c base address */
+	u32		board_rev_gpios;	/* Board revision GPIOs */
+	enum mem_manuf	mem_manuf;	/* Memory Manufacturer */
 } __attribute__((__packed__));
 #endif
 
-- 
1.7.4.4