[U-Boot] [PATCH v7 15/19] nand: mxc: Switch NAND SPL to generic SPL

[Benoît Thébaudeau]

Hi Troy,

On Friday, February 22, 2013 10:30:21 PM, Troy Kisky wrote:
> On 2/22/2013 2:13 PM, Benoît Thébaudeau wrote:
> > Hi Fabio,
> >
> > On Friday, February 22, 2013 10:06:42 PM, Fabio Estevam wrote:
> >> Hi Benoît,
> >>
> >> On Fri, Feb 22, 2013 at 5:09 PM, Benoît Thébaudeau
> >> <benoit.thebaudeau at advansee.com> wrote:
> >>
> >>> It looks very much like the issue that Marek had on i.MX53 (which
> >>> self-resolved
> >>> for an unknown reason).
> >>>
> >>> Try to enable the debug trace to see if anything else is printed after
> >>> display_dram_config(). I would especially be interested in:
> >>>          debug("relocation Offset is: %08lx\n", gd->reloc_off);
> >>>          debug("monitor flash len: %08lX\n", monitor_flash_len);
> >> Here is the output:
> >>
> >> U-Boot 2013.01 (Feb 22 2013 - 18:00:50)
> >>
> >> U-Boot code: 87F00000 -> 87F2C184  BSS: -> 87F311B4
> >> CPU:   Freescale i.MX31 rev 2.0 at 532 MHz.
> >> Reset cause: POR
> >> Board: MX31PDK
> >> monitor len: 000311B4
> >> ramsize: 08000000
> >> TLB table from 87ff0000 to 87ff4000
> >> Top of RAM usable for U-Boot at: 87ff0000
> >> Reserving 196k for U-Boot at: 87fbe000
> >> Reserving 640k for malloc() at: 87f1e000
> >> Reserving 32 Bytes for Board Info at: 87f1dfe0
> >> Reserving 128 Bytes for Global Data at: 87f1df60
> >> New Stack Pointer is: 87f1df50
> >> RAM Configuration:
> >> Bank #0: 80000000 128 MiB
> >> relocation Offset is: 000be000
> > CONFIG_SYS_TEXT_BASE seems fine according to this trace. But anyway, can
> > you
> > test with this change in mx31pdk.h?
> > #define CONFIG_SPL_TEXT_BASE	0x84000000
> > #define CONFIG_SYS_TEXT_BASE	0x83000000
> >
> > Can you try to revert 10/19, only for arm1136/start.S (1 line to restore)?
> > There
> > is an issue in this patch that I have already fixed in my v8.
> >
> > Best regards,
> > Benoît
> > _______________________________________________
> >
> How about changing
> 
> #define CONFIG_SYS_NAND_U_BOOT_SIZE   0x30000
> #define CONFIG_SYS_NAND_U_BOOT_SIZE   0x32000
> 
> is see monitor len: 311B4 above is over 0x30000
> 
> 
> Please excuse me if they are unrelated.

That could be it. Thanks! Fabio, please try.

Best regards,
Benoît