[U-Boot] [PATCH v7 15/19] nand: mxc: Switch NAND SPL to generic SPL

Marek Vasut marex at denx.de
Sat Feb 23 00:56:32 CET 2013


Dear Benoît Thébaudeau,

> Dear Marek Vasut,
> 
> On Saturday, February 23, 2013 12:11:47 AM, Marek Vasut wrote:
> > Dear Fabio Estevam,
> > 
> > > On Fri, Feb 22, 2013 at 7:42 PM, Benoît Thébaudeau
> > > 
> > > <benoit.thebaudeau at advansee.com> wrote:
> > > > Great! So can you confirm that for my series, all I have to change
> > > > is: #define CONFIG_SYS_NAND_U_BOOT_SIZE   0x32000
> > > 
> > > Yes, correct. This is the only change you need to do in your series.
> > > 
> > > > Did you also have a chance to test nand commands on mx53ard?
> > > 
> > > Not yet, will try this early next week.
> > > 
> > > Thanks for providing SPL NAND support for imx!
> > 
> > We won't need SPL on mx53, I pretty much have patches for mx53 NAND boot
> > without
> > SPL ready, just need some polishment.
> 
> Cool.
> 
> How did you omit the SPL? Are you using the FCB bad block feature to handle
> these? Have you tested that it still works if your image spans several NAND
> blocks among which are some bad blocks (with bad blocks having been skipped
> while programming the image)?

My NAND is almost new by now, so I haven't.

Best regards,
Marek Vasut


More information about the U-Boot mailing list