[U-Boot] [PATCH v3 2/3] LaCie/common: Uses #defines for ethernet phy leds setup

[Frédéric Leroy]

The CloudBox device have a different ethernet phy setup than other ns2
devices.
Prepare source to use different init registers

Signed-off-by: Frédéric Leroy <fredo at starox.org>
---
 board/LaCie/common/common.c | 13 ++++++++++---
 1 file changed, 10 insertions(+), 3 deletions(-)

diff --git a/board/LaCie/common/common.c b/board/LaCie/common/common.c
index a62bf9f..85480e7 100644
--- a/board/LaCie/common/common.c
+++ b/board/LaCie/common/common.c
@@ -21,6 +21,12 @@
 #define MV88E1116_RGMII_TXTM_CTRL	(1 << 4)
 #define MV88E1116_RGMII_RXTM_CTRL	(1 << 5)
 
+#if !defined(MII_MARVELL_LED_REG)
+# define MII_MARVELL_LED_REG 16
+# define MII_MARVELL_LED_MASK 0xf0
+# define MII_MARVELL_LED_VALUE 0x0f
+#endif
+
 void mv_phy_88e1116_init(const char *name, u16 phyaddr)
 {
 	u16 reg;
@@ -53,9 +59,10 @@ void mv_phy_88e1318_init(const char *name, u16 phyaddr)
 	 * Set control mode 4 for LED[0].
 	 */
 	miiphy_write(name, phyaddr, MII_MARVELL_PHY_PAGE, 3);
-	miiphy_read(name, phyaddr, 16, &reg);
-	reg |= 0xf;
-	miiphy_write(name, phyaddr, 16, reg);
+	miiphy_read(name, phyaddr, MII_MARVELL_LED_REG, &reg);
+	reg &= MII_MARVELL_LED_MASK;
+	reg |= MII_MARVELL_LED_VALUE;
+	miiphy_write(name, phyaddr, MII_MARVELL_LED_REG, reg);
 
 	/*
 	 * Enable RGMII delay on Tx and Rx for CPU port
-- 
1.8.1.2