[U-Boot] [PATCH 1/5] omap3_beagle: remove JFFS2 support.

Joel Fernandes joelf at ti.com
Fri Jul 12 04:49:20 CEST 2013


On Thu, Jul 11, 2013 at 4:52 PM, Nishanth Menon <nm at ti.com> wrote:
> We do not use JFFS2 by default and it conflicts with
> CONFIG_CMD_FS_GENERIC (ls command is the same). Since most of our
> BOOTCMD can be simplified by using the FS_GENERIC, dropping JFFS2
>
> Signed-off-by: Nishanth Menon <nm at ti.com>
> ---
>  include/configs/omap3_beagle.h |    8 --------
>  1 file changed, 8 deletions(-)
>
> diff --git a/include/configs/omap3_beagle.h b/include/configs/omap3_beagle.h
> index 48ce4c0..9adf4a5 100644
> --- a/include/configs/omap3_beagle.h
> +++ b/include/configs/omap3_beagle.h
> @@ -150,7 +150,6 @@
>  #define CONFIG_CMD_CACHE
>  #define CONFIG_CMD_EXT2                /* EXT2 Support                 */
>  #define CONFIG_CMD_FAT         /* FAT support                  */
> -#define CONFIG_CMD_JFFS2       /* JFFS2 Support                */
>  #define CONFIG_CMD_MTDPARTS    /* Enable MTD parts commands */
>  #define CONFIG_MTD_DEVICE      /* needed for mtdparts commands */
>  #define MTDIDS_DEFAULT                 "nand0=nand"
> @@ -203,13 +202,6 @@
>
>  #define CONFIG_SYS_MAX_NAND_DEVICE     1               /* Max number of NAND */
>                                                         /* devices */
> -#define CONFIG_JFFS2_NAND
> -/* nand device jffs2 lives on */
> -#define CONFIG_JFFS2_DEV               "nand0"
> -/* start of jffs2 partition */
> -#define CONFIG_JFFS2_PART_OFFSET       0x680000
> -#define CONFIG_JFFS2_PART_SIZE         0xf980000       /* size of jffs2 */
>

Minor nit, can we perhaps leave the JFFS configuration and only remove/comment
CONFIG_CMD_JFFS. That way we wont lose these paritition offsets/size for folks
who might need them.

Otherwise,
Acked-by: Joel Fernandes <joelf at ti.com>

Thanks,

-Joel


More information about the U-Boot mailing list