[U-Boot] [PATCH] mxc_gpio: Correct the GPIO handling in gpio_direction_output()

[Stefano Babic]

On 15/07/2013 15:58, Dirk Behme wrote:
> Setting the direction and an output value should be done by
> 
> First, set the desired output value.
> 
> Then, switch to output.
> 
> If this is done in the inverse order, like at the moment,
> there can be a glitch on the GPIO line while switching first
> the old output value and aftwards the new one.
> 
> Fix this by inverting the order of the direction/set_value
> calls.
> 
> Signed-off-by: Dirk Behme <dirk.behme at de.bosch.com>
> ---

Applied to u-boot-imx, thanks !

Best regards,
SWtefano Babic


-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================