[U-Boot] [PATCH 1/2] usb: ehci-mx5: Remove unneeded write to cscmr1 register

[Fabio Estevam]

From: Fabio Estevam <fabio.estevam at freescale.com>

Currently we have the following behavior in ehci_hcd_init()

- Read csmr1 register, clear bit 26 and then set bit 26.

However a little bit later we call set_usb_phy_clk() which clears bit 26, so
let's get rid of the unnecessary code.

Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>
---
 drivers/usb/host/ehci-mx5.c | 9 ---------
 1 file changed, 9 deletions(-)

diff --git a/drivers/usb/host/ehci-mx5.c b/drivers/usb/host/ehci-mx5.c
index f43c38d..6178a1d 100644
--- a/drivers/usb/host/ehci-mx5.c
+++ b/drivers/usb/host/ehci-mx5.c
@@ -229,15 +229,6 @@ void __weak board_ehci_hcd_postinit(struct usb_ehci *ehci, int port)
 int ehci_hcd_init(int index, struct ehci_hccr **hccr, struct ehci_hcor **hcor)
 {
 	struct usb_ehci *ehci;
-#ifdef CONFIG_MX53
-	struct clkctl *sc_regs = (struct clkctl *)CCM_BASE_ADDR;
-	u32 reg;
-
-	reg = __raw_readl(&sc_regs->cscmr1) & ~(1 << 26);
-	/* derive USB PHY clock multiplexer from PLL3 */
-	reg |= 1 << 26;
-	__raw_writel(reg, &sc_regs->cscmr1);
-#endif
 
 	set_usboh3_clk();
 	enable_usboh3_clk(1);
-- 
1.8.1.2