[U-Boot] [PATCH 3/5] Tegra30: MMC: Add SD bus power-rail and SDMMC pad init routines

[Tom Warren]

On Tue, Mar 5, 2013 at 10:03 AM, Stephen Warren <swarren at wwwdotorg.org> wrote:
> On 03/05/2013 08:28 AM, Tom Warren wrote:
>> On Mon, Mar 4, 2013 at 5:28 PM, Stephen Warren <swarren at wwwdotorg.org> wrote:
>>> On 03/04/2013 04:11 PM, Tom Warren wrote:
>>>> On Wed, Feb 27, 2013 at 11:08 AM, Stephen Warren <swarren at wwwdotorg.org> wrote:
>>>>> On 02/27/2013 09:59 AM, Tom Warren wrote:
>>>>>> On Tue, Feb 26, 2013 at 4:26 PM, Stephen Warren <swarren at wwwdotorg.org> wrote:
> ...
>>>>> For the pinmux registers, I think they should be programmed by the
>>>>> pinmux driver at the same time as the rest of the pinmux is programmed.
>>>>
>>>> Technically, they're not pinmux registers (PINMUX_AUX_ space), but GP
>>>> regs (APB_MISC_GP_ space). Since the pinmux _code_ (no pinmux driver
>>>> is used in Tegra U-Boot)
>>>
>>> The distinction isn't relevant for this discussion. Anyway, there really
>>> is a driver...
>>
>> I must be dense. Please point it out to me. It is relevant, because
>> you've asked to put the GP register writes in the pinmux driver.
>
> [swarren at swarren-lx1 u-boot]$ find|grep pinmux|grep tegra|grep \\.c$
> ./arch/arm/cpu/tegra30-common/pinmux.c
> ./arch/arm/cpu/tegra114-common/pinmux.c
> ./arch/arm/cpu/tegra20-common/pinmux.c
OK, there's a semantic chasm here. This is not a 'driver' in my mind -
it's just the pinmux code to set the bits in the PINMUX_AUX regs, and
over half of it's tables & structs. Again, T30 reads in a few tables
of pinmux/pingroup settings, and slams 'em out to the regs using the
functions in pinmux.c (set_tristate, set_pullupdown, etc.).

So would you be satisfied if I removed the GP sdio pad cfg writes from
the common board-level code (common/board.c) and put them in a
function that's called during pinmux_init(), early on in
board_early_init_f()? That'll preclude being able to parse the mmc_id
to see if I need to write SDIO1CFG or SDIO3CFG, so I'll have to slam
'em both, but that should be OK.