[U-Boot] [PATCH V2] Add Boundary Devices Nitrogen6X boards

[Eric Nelson]

Hi Troy,

On 03/09/2013 05:49 PM, Troy Kisky wrote:
> On 3/9/2013 5:04 PM, Eric Nelson wrote:
>> diff --git a/board/boundary/nitrogen6x/nitrogen6x.c
>> b/board/boundary/nitrogen6x/nitrogen6x.c
>> new file mode 100644
>> index 0000000..147bd91
>> --- /dev/null
>> +++ b/board/boundary/nitrogen6x/nitrogen6x.c
>> @@ -0,0 +1,895 @@
>> +int dram_init(void)
>> +{
>> +    gd->ram_size = get_ram_size((void *)PHYS_SDRAM, PHYS_SDRAM_SIZE);
>
> This will hang a solo if
>
> PHYS_SDRAM_SIZE is bigger than actual memory size
>
> which makes calling get_ram_size pretty useless.
>

Since the DDR size must be known in the memory configuration
file, this is equivalent to saying:

	get_ram_size() will hang if we run the **wrong**
	U-Boot binary on the device

I think this is true for other reasons as well (SATA?).

The DDR size in this translated from the boards.cfg file,
which defines CONFIG_DDR_MB for each configuration
and nitrogen6x.h, which uses it to define PHYS_SDRAM_SIZE

+#define PHYS_SDRAM_SIZE	(CONFIG_DDR_MB * 1024 * 1024)

But your point about calling get_ram_size() being useless
is probably true.

Testing for RAM that we need to configure doesn't add anything.

Regards,


Eric