[U-Boot] [PATCH v2 0/15] arm: kconfig: move board select menus and other settings to SoC dir

[Masahiro YAMADA]

Hi Tom,


2014-08-06 12:17 GMT+09:00 Masahiro Yamada <yamada.m at jp.panasonic.com>:
> There are lots of boards supported in ARM architecture.
> The board select menu in arch/arm/Kconfig is already too fat.
>
> This series introduces platform select between arch select and
> board select.
>
>   ARCH select (ARM)
>    |-- Platform select
>        |-- Board select
>
> Many (not all) of boards have been moved to $(SOC)/Kconfig.
>
> I built all the boards and confirmed the same binaries are
> produced with/without thie series.
>
> I am including a patch to remove "omap5912osk" board in this series
> to avoid conflicts.
>
>  Prerequisites
>  -------------
> [1]
> http://patchwork.ozlabs.org/patch/374758/
> to avoid a conflict in drivers/usb/gadget/Makefile
>
> [2]
> http://patchwork.ozlabs.org/patch/374416/
> to avoid a conflict in doc/README.scrapyard
>
> [3]
> http://patchwork.ozlabs.org/patch/375467/
> to avoid a conflict in configs/jetson-tk1_defconfig
>


New boards are coming all the time, for example
http://patchwork.ozlabs.org/patch/376782/

The problem is this series causes big conflicts with such patches.

Because this series was reviewed, acked or tested by some ARM-SoC maintainers,
I think this should go directly into u-boot/master asap along with
some prerequisites.

What do you think? Should we wait for Albert's review?



Best Regards
Masahiro Yamada