[U-Boot] [PATCH v4] net: fec_mxc: Poll FEC_TBD_READY after polling TDAR

[Marek Vasut]

On Thursday, August 21, 2014 at 07:10:32 PM, Fabio Estevam wrote:
> When testing the FEC driver on a mx6solox we noticed that the TDAR bit gets
> always cleared prior then the READY bit is set in the last BD, which causes
> FEC transmission to fail.
> 
> As explained by Ye Li:
> 
> "The TDAR bit is set when the descriptors are all out from TX ring, but the
> descriptor properly is in transmitting not READY.

Again, I do not understand this sentence :-(

> These are two signals,
> and in Ic simulation, we found the TDAR always clear prior than the READY
> bit of last BD.

And this is the behavior of which version of the FEC IP, the "old" one or the 
one present in MX6slx ?

> In mx6solox, we use a latest version of FEC IP. It looks
> the intrinsic behave of TDAR bit is changed in this FEC version, not any
> bug in mx6sx."
>
> Fix this by polling the READY bit of BD after the TDAR polling, which
> covers the mx6solox case and does not harm for the other SoCs.
> 
> Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>

[...]

Best regards,
Marek Vasut