[U-Boot] [U-Boot, U-boot, v3, 1/3] mtd: nand: davinci: allow to change ecclayout by ecclayout command

[Ivan Khoronzhuk]

On 08/25/2014 10:14 PM, Tom Rini wrote:
> On Tue, Jun 24, 2014 at 04:49:04PM +0300, Khoronzhuk, Ivan wrote:
>
>> From: WingMan Kwok <w-kwok2 at ti.com>
>>
>> This patch adds opportunity to change ecclayout of current nand
>> device during runtime. So we can change the current nand device
>> ecclayout using the "nand ecclayout set" command before writing
>> the data to nand flash.
>>
>> Signed-off-by: Hao Zhang <hzhang at ti.com>
>> Signed-off-by: WingMan Kwok <w-kwok2 at ti.com>
>> Signed-off-by: Ivan Khoronzhuk <ivan.khoronzhuk at ti.com>
> Applied to u-boot-ti/master, thanks!
>

Sorry Tom, but the subj patch as
entire "[U-boot] [Patch v3 0/3] keystone: nand: add additional nand 
ecclayout" series
was completely replaced by "[U-boot] [Patch 0/3] Add support for NAND 
U-boot image upgrade" series
(http://lists.denx.de/pipermail/u-boot/2014-July/182956.html)
which has been applied already.

Hence, this patch as all patches from this series would be better to 
remove...

Once again sorry. I should specify here about this.

-- 
Regards,
Ivan Khoronzhuk