[U-Boot] [PATCH 2/3] configs: zynq: Add config support for ZYBO

[Jagan Teki]

On 28 August 2014 16:46, Peter Crosthwaite <crosthwaitepeter at gmail.com> wrote:
> From: Tinghui Wang <steven.wang at digilentinc.com>
>
> This patch adds config support needed for ZYBO target and has
> been tested on Rev. B ZYBO hardware.
>
> Signed-off-by: Tinghui Wang <steven.wang at digilentinc.com>
> [PC changes:
>  * Dropped boards.cfg change (rebase conflict)
>  * Dropped custom u-boot env
>  * Added DTS
>  * Misc forward-porting changes
> ]
> Signed-off-by: Peter Crosthwiate <crosthwaite.peter at gmail.com>
>
> ---
> I have dropped the custom u-boot env from the original patch,
> as I'm not sure what the purpose was and I didn't need it for ZYBO SPL.
> ---
>  include/configs/zynq_zybo.h | 31 +++++++++++++++++++++++++++++++
>  1 file changed, 31 insertions(+)
>  create mode 100644 include/configs/zynq_zybo.h
>
> diff --git a/include/configs/zynq_zybo.h b/include/configs/zynq_zybo.h
> new file mode 100644
> index 0000000..c167207
> --- /dev/null
> +++ b/include/configs/zynq_zybo.h
> @@ -0,0 +1,31 @@
> +/*
> + * (C) Copyright 2012 Xilinx
> + * (C) Copyright 2014 Digilent Inc.
> + *
> + * Configuration for Zynq Development Board - ZYBO
> + * See zynq_common.h for Zynq common configs

typo - it's zynq-common.h

> + *
> + * SPDX-License-Identifier:    GPL-2.0+
> + */
> +
> +#ifndef __CONFIG_ZYNQ_ZYBO_H
> +#define __CONFIG_ZYNQ_ZYBO_H
> +
> +#define CONFIG_SYS_SDRAM_SIZE (512 * 1024 * 1024)
> +
> +#define CONFIG_ZYNQ_SERIAL_UART1
> +#define CONFIG_ZYNQ_GEM0
> +#define CONFIG_ZYNQ_GEM_PHY_ADDR0      0
> +
> +#define CONFIG_SYS_NO_FLASH
> +
> +#define CONFIG_ZYNQ_SDHCI0
> +#define CONFIG_ZYNQ_BOOT_FREEBSD
> +#define CONFIG_DEFAULT_DEVICE_TREE     zynq-zybo
> +
> +/* Define ZYBO PS Clock Frequency to 50MHz */
> +#define CONFIG_ZYNQ_PS_CLK_FREQ        50000000UL
> +
> +#include <configs/zynq-common.h>
> +
> +#endif /* __CONFIG_ZYNQ_ZYBO_H */
> --
> 1.9.1

thanks!
-- 
Jagan.