[U-Boot] [PATCH] mtd: nand: mxs: Add support for multiple NAND chips

[Marek Vasut]

On Sunday, December 07, 2014 at 12:45:30 AM, Scott Wood wrote:
> On Sat, 2014-12-06 at 14:07 +0100, Marek Vasut wrote:
> > On Tuesday, December 02, 2014 at 02:26:14 PM, Stefan Roese wrote:
> > > This patch adds support for multiple NAND chips connected to the
> > > i.MX6. Linux already supports this configuration. So lets port
> > > the missing features to the U-Boot driver to support more than
> > > one NAND chip here as well.
> > > 
> > > The necessary changes in detail are:
> > > 
> > > - Only use DMA channel 0 for all NAND chips:
> > >   Linux: a7c12d01 (mtd: gpmi: use DMA channel 0 for all the
> > >   
> > >                    nand chips)
> > >          
> > >          d159d8b7 (mtd: gpmi: decouple the chip select from
> > >          
> > >                    the DMA channel)
> > > 
> > > - On i.MX6 only use ready/busy pin for CS0:
> > >   Linux: 7caa4fd2 (mtd: gpmi: imx6: fix the wrong method for
> > >   
> > >                    checking ready/busy)
> > > 
> > > To enable this feature the board needs to configure
> > > CONFIG_SYS_NAND_MAX_CHIPS to 2 (or more).
> > > 
> > > With these changes I'm able to detect and acces 2 NAND chips:
> > > 
> > > => nand device
> > > 
> > > Device 0: 2x nand0, sector size 128 KiB
> > > 
> > >   Page size      2048 b
> > >   OOB size         64 b
> > >   Erase size   131072 b
> > 
> > Shouldn't you see "Device 0" and "Device 1" ?
> 
> The "2x" indicates that there are two identical chips being treated as a
> single device (chip->numchips).

Is that correct ? What if I have two different NAND chips on this controller?

Best regards,
Marek Vasut