[U-Boot] [PATCH v2 12/13] ARM: atmel: sama5d4ek: enable SPL support
Bo Shen
voice.shen at atmel.com
Mon Dec 15 06:24:38 CET 2014
The sama5d4ek support boot up from NAND flash, SD/MMC card and
also the SPI flash.
Signed-off-by: Bo Shen <voice.shen at atmel.com>
---
Changes in v2:
- change CONFIG_SYS_MMC_SD_FS_BOOT_PARTITION to CONFIG_SYS_MMCSD_FS_BOOT_PARTITION
arch/arm/Kconfig | 1 +
board/atmel/sama5d4ek/sama5d4ek.c | 85 +++++++++++++++++++++++++++++++++++
configs/sama5d4ek_mmc_defconfig | 1 +
configs/sama5d4ek_nandflash_defconfig | 1 +
configs/sama5d4ek_spiflash_defconfig | 1 +
include/configs/sama5d4ek.h | 56 +++++++++++++++++++++++
6 files changed, 145 insertions(+)
diff --git a/arch/arm/Kconfig b/arch/arm/Kconfig
index 2b0d2c9..9a39e09 100644
--- a/arch/arm/Kconfig
+++ b/arch/arm/Kconfig
@@ -522,6 +522,7 @@ config TARGET_SAMA5D4_XPLAINED
config TARGET_SAMA5D4EK
bool "Support sama5d4ek"
select CPU_V7
+ select SUPPORT_SPL
config TARGET_BCM28155_AP
bool "Support bcm28155_ap"
diff --git a/board/atmel/sama5d4ek/sama5d4ek.c b/board/atmel/sama5d4ek/sama5d4ek.c
index e014e0a..f8cff68 100644
--- a/board/atmel/sama5d4ek/sama5d4ek.c
+++ b/board/atmel/sama5d4ek/sama5d4ek.c
@@ -10,6 +10,7 @@
#include <asm/arch/at91_common.h>
#include <asm/arch/at91_pmc.h>
#include <asm/arch/at91_rstc.h>
+#include <asm/arch/atmel_mpddrc.h>
#include <asm/arch/atmel_usba_udc.h>
#include <asm/arch/gpio.h>
#include <asm/arch/clk.h>
@@ -326,3 +327,87 @@ int board_eth_init(bd_t *bis)
return rc;
}
+
+/* SPL */
+#ifdef CONFIG_SPL_BUILD
+void spl_board_init(void)
+{
+#ifdef CONFIG_SYS_USE_MMC
+ sama5d4ek_mci1_hw_init();
+#elif CONFIG_SYS_USE_NANDFLASH
+ sama5d4ek_nand_hw_init();
+#elif CONFIG_SYS_USE_SERIALFLASH
+ sama5d4ek_spi0_hw_init();
+#endif
+}
+
+static void ddr2_conf(struct atmel_mpddr *ddr2)
+{
+ ddr2->md = (ATMEL_MPDDRC_MD_DBW_32_BITS | ATMEL_MPDDRC_MD_DDR2_SDRAM);
+
+ ddr2->cr = (ATMEL_MPDDRC_CR_NC_COL_10 |
+ ATMEL_MPDDRC_CR_NR_ROW_14 |
+ ATMEL_MPDDRC_CR_CAS_DDR_CAS3 |
+ ATMEL_MPDDRC_CR_NB_8BANKS |
+ ATMEL_MPDDRC_CR_NDQS_DISABLED |
+ ATMEL_MPDDRC_CR_DECOD_INTERLEAVED |
+ ATMEL_MPDDRC_CR_UNAL_SUPPORTED);
+
+ ddr2->rtr = 0x2b0;
+
+ ddr2->tpr0 = (8 << ATMEL_MPDDRC_TPR0_TRAS_OFFSET |
+ 3 << ATMEL_MPDDRC_TPR0_TRCD_OFFSET |
+ 3 << ATMEL_MPDDRC_TPR0_TWR_OFFSET |
+ 10 << ATMEL_MPDDRC_TPR0_TRC_OFFSET |
+ 3 << ATMEL_MPDDRC_TPR0_TRP_OFFSET |
+ 2 << ATMEL_MPDDRC_TPR0_TRRD_OFFSET |
+ 2 << ATMEL_MPDDRC_TPR0_TWTR_OFFSET |
+ 2 << ATMEL_MPDDRC_TPR0_TMRD_OFFSET);
+
+ ddr2->tpr1 = (2 << ATMEL_MPDDRC_TPR1_TXP_OFFSET |
+ 200 << ATMEL_MPDDRC_TPR1_TXSRD_OFFSET |
+ 25 << ATMEL_MPDDRC_TPR1_TXSNR_OFFSET |
+ 23 << ATMEL_MPDDRC_TPR1_TRFC_OFFSET);
+
+ ddr2->tpr2 = (7 << ATMEL_MPDDRC_TPR2_TFAW_OFFSET |
+ 2 << ATMEL_MPDDRC_TPR2_TRTP_OFFSET |
+ 3 << ATMEL_MPDDRC_TPR2_TRPA_OFFSET |
+ 2 << ATMEL_MPDDRC_TPR2_TXARDS_OFFSET |
+ 8 << ATMEL_MPDDRC_TPR2_TXARD_OFFSET);
+}
+
+void mem_init(void)
+{
+ struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC;
+ struct atmel_mpddr ddr2;
+
+ ddr2_conf(&ddr2);
+
+ /* enable MPDDR clock */
+ at91_periph_clk_enable(ATMEL_ID_MPDDRC);
+ writel(0x4, &pmc->scer);
+
+ /* DDRAM2 Controller initialize */
+ ddr2_init(ATMEL_BASE_DDRCS, &ddr2);
+}
+
+void at91_pmc_init(void)
+{
+ struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC;
+ u32 tmp;
+
+ tmp = AT91_PMC_PLLAR_29 |
+ AT91_PMC_PLLXR_PLLCOUNT(0x3f) |
+ AT91_PMC_PLLXR_MUL(87) |
+ AT91_PMC_PLLXR_DIV(1);
+ at91_plla_init(tmp);
+
+ writel(0x0 << 8, &pmc->pllicpr);
+
+ tmp = AT91_PMC_MCKR_H32MXDIV |
+ AT91_PMC_MCKR_PLLADIV_2 |
+ AT91_PMC_MCKR_MDIV_3 |
+ AT91_PMC_MCKR_CSS_PLLA;
+ at91_mck_init(tmp);
+}
+#endif
diff --git a/configs/sama5d4ek_mmc_defconfig b/configs/sama5d4ek_mmc_defconfig
index 16a5ed7..aafb4c2 100644
--- a/configs/sama5d4ek_mmc_defconfig
+++ b/configs/sama5d4ek_mmc_defconfig
@@ -1,3 +1,4 @@
+CONFIG_SPL=y
CONFIG_SYS_EXTRA_OPTIONS="SAMA5D4,SYS_USE_MMC"
+S:CONFIG_ARM=y
+S:CONFIG_TARGET_SAMA5D4EK=y
diff --git a/configs/sama5d4ek_nandflash_defconfig b/configs/sama5d4ek_nandflash_defconfig
index 8b7fbc3..d430fa7 100644
--- a/configs/sama5d4ek_nandflash_defconfig
+++ b/configs/sama5d4ek_nandflash_defconfig
@@ -1,3 +1,4 @@
+CONFIG_SPL=y
CONFIG_SYS_EXTRA_OPTIONS="SAMA5D4,SYS_USE_NANDFLASH"
+S:CONFIG_ARM=y
+S:CONFIG_TARGET_SAMA5D4EK=y
diff --git a/configs/sama5d4ek_spiflash_defconfig b/configs/sama5d4ek_spiflash_defconfig
index 63e9b6c..796fa4b 100644
--- a/configs/sama5d4ek_spiflash_defconfig
+++ b/configs/sama5d4ek_spiflash_defconfig
@@ -1,3 +1,4 @@
+CONFIG_SPL=y
CONFIG_SYS_EXTRA_OPTIONS="SAMA5D4,SYS_USE_SERIALFLASH"
+S:CONFIG_ARM=y
+S:CONFIG_TARGET_SAMA5D4EK=y
diff --git a/include/configs/sama5d4ek.h b/include/configs/sama5d4ek.h
index 09ab4d7..9e1b86a 100644
--- a/include/configs/sama5d4ek.h
+++ b/include/configs/sama5d4ek.h
@@ -20,7 +20,9 @@
#define CONFIG_ARCH_CPU_INIT
+#ifndef CONFIG_SPL_BUILD
#define CONFIG_SKIP_LOWLEVEL_INIT
+#endif
#define CONFIG_BOARD_EARLY_INIT_F
#define CONFIG_DISPLAY_CPUINFO
@@ -66,8 +68,12 @@
#define CONFIG_SYS_SDRAM_BASE ATMEL_BASE_DDRCS
#define CONFIG_SYS_SDRAM_SIZE 0x20000000
+#ifdef CONFIG_SPL_BUILD
+#define CONFIG_SYS_INIT_SP_ADDR 0x210000
+#else
#define CONFIG_SYS_INIT_SP_ADDR \
(CONFIG_SYS_SDRAM_BASE + 4 * 1024 - GENERATED_GBL_DATA_SIZE)
+#endif
#define CONFIG_SYS_LOAD_ADDR 0x22000000 /* load address */
@@ -219,4 +225,54 @@
/* Size of malloc() pool */
#define CONFIG_SYS_MALLOC_LEN (4 * 1024 * 1024)
+
+/* SPL */
+#define CONFIG_SPL_FRAMEWORK
+#define CONFIG_SPL_TEXT_BASE 0x200000
+#define CONFIG_SPL_MAX_SIZE 0x10000
+#define CONFIG_SPL_BSS_START_ADDR 0x20000000
+#define CONFIG_SPL_BSS_MAX_SIZE 0x80000
+#define CONFIG_SYS_SPL_MALLOC_START 0x20080000
+#define CONFIG_SYS_SPL_MALLOC_SIZE 0x80000
+
+#define CONFIG_SPL_LIBCOMMON_SUPPORT
+#define CONFIG_SPL_LIBGENERIC_SUPPORT
+#define CONFIG_SPL_GPIO_SUPPORT
+#define CONFIG_SPL_SERIAL_SUPPORT
+
+#define CONFIG_SPL_BOARD_INIT
+#define CONFIG_SYS_MONITOR_LEN (512 << 10)
+
+#ifdef CONFIG_SYS_USE_MMC
+#define CONFIG_SPL_LDSCRIPT arch/arm/cpu/at91-common/u-boot-spl.lds
+#define CONFIG_SPL_MMC_SUPPORT
+#define CONFIG_SYS_U_BOOT_MAX_SIZE_SECTORS 0x400
+#define CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR 0x200
+#define CONFIG_SYS_MMCSD_FS_BOOT_PARTITION 1
+#define CONFIG_SPL_FS_LOAD_PAYLOAD_NAME "u-boot.img"
+#define CONFIG_SPL_FAT_SUPPORT
+#define CONFIG_SPL_LIBDISK_SUPPORT
+
+#elif CONFIG_SYS_USE_NANDFLASH
+#define CONFIG_SPL_NAND_SUPPORT
+#define CONFIG_SPL_NAND_DRIVERS
+#define CONFIG_SPL_NAND_BASE
+#define CONFIG_PMECC_CAP 8
+#define CONFIG_PMECC_SECTOR_SIZE 512
+#define CONFIG_SYS_NAND_U_BOOT_OFFS 0x40000
+#define CONFIG_SYS_NAND_5_ADDR_CYCLE
+#define CONFIG_SYS_NAND_PAGE_SIZE 0x1000
+#define CONFIG_SYS_NAND_PAGE_COUNT 64
+#define CONFIG_SYS_NAND_OOBSIZE 224
+#define CONFIG_SYS_NAND_BLOCK_SIZE 0x40000
+#define CONFIG_SYS_NAND_BAD_BLOCK_POS 0x0
+#define CONFIG_SPL_GENERATE_ATMEL_PMECC_HEADER
+
+#elif CONFIG_SYS_USE_SERIALFLASH
+#define CONFIG_SPL_SPI_SUPPORT
+#define CONFIG_SPL_SPI_FLASH_SUPPORT
+#define CONFIG_SPL_SPI_LOAD
+#define CONFIG_SYS_SPI_U_BOOT_OFFS 0x20000
+
+#endif
#endif
--
2.1.0.24.g4109c28
More information about the U-Boot
mailing list