[U-Boot] [PATCH 2/4] mx6sx: Add pin definitions

[Eric Nelson]

Hi Stefano,

On 06/17/2014 08:40 AM, Stefano Babic wrote:
> Hi Fabio,
> 
> On 14/06/2014 22:29, Fabio Estevam wrote:
>> From: Fabio Estevam <fabio.estevam at freescale.com>
>>
>> Add the pin definitions for mx6sx.
>>
> 
> A base question. There was a lot of work to try to abstract the pin
> definitions for the i.MX6 SOCs. For QUAD and DUAL, the pins are defined
> with the MX6_PAD_DECL macro. It works differently according to the
> selected CPU. If more as one CPU is supported in the same image, the
> check is done at runtime.
> 
> Previously, we had IOMUX_PAD, I know. Is there any special reason we
> cannot use MX6_PAD_DECL even for this new SOC ? I will not want to go
> back ignoring a lot of work that was done to merge the SOCs together.
> 

The rationale for the MX6_PAD_DECL came from the fact that the
i.MX6DQ and i.MX6DLS cpu variants had different address schemes,
but were pin-compatible.

The i.MX6SL (and i.MX6SX) are not, so any board supporting these
processors only supports that processor.

Regards,


Eric