[U-Boot] [PATCH v2 2/3] mtd: nand: atmel: prepare for nand spl boot support
Bo Shen
voice.shen at atmel.com
Mon Mar 3 07:47:16 CET 2014
Prepare for nand spl boot support. It supports nand software ECC and
hardware PMECC.
This patch is take <drivers/mtd/nand/nand_spl_simple.c> as reference.
Signed-off-by: Bo Shen <voice.shen at atmel.com>
---
Changes in v2:
- Address the comments from Scott Wood
drivers/mtd/nand/atmel_nand.c | 208 ++++++++++++++++++++++++++++++++++++++++++
include/nand.h | 6 ++
2 files changed, 214 insertions(+)
diff --git a/drivers/mtd/nand/atmel_nand.c b/drivers/mtd/nand/atmel_nand.c
index 05ddfbb..e1fc48f 100644
--- a/drivers/mtd/nand/atmel_nand.c
+++ b/drivers/mtd/nand/atmel_nand.c
@@ -31,6 +31,10 @@
#ifdef CONFIG_ATMEL_NAND_HW_PMECC
+#ifdef CONFIG_SPL_BUILD
+#undef CONFIG_SYS_NAND_ONFI_DETECTION
+#endif
+
struct atmel_nand_host {
struct pmecc_regs __iomem *pmecc;
struct pmecc_errloc_regs __iomem *pmerrloc;
@@ -1169,6 +1173,209 @@ static int at91_nand_ready(struct mtd_info *mtd)
}
#endif
+#ifdef CONFIG_SPL_BUILD
+/* The following code is for SPL */
+static nand_info_t mtd;
+static struct nand_chip nand_chip;
+
+static int nand_command(int block, int page, uint32_t offs, u8 cmd)
+{
+ struct nand_chip *this = mtd.priv;
+ int page_addr = page + block * CONFIG_SYS_NAND_PAGE_COUNT;
+ void (*hwctrl)(struct mtd_info *mtd, int cmd,
+ unsigned int ctrl) = this->cmd_ctrl;
+
+ while (this->dev_ready(&mtd))
+ ;
+
+ if (cmd == NAND_CMD_READOOB) {
+ offs += CONFIG_SYS_NAND_PAGE_SIZE;
+ cmd = NAND_CMD_READ0;
+ }
+
+ hwctrl(&mtd, cmd, NAND_CTRL_CLE | NAND_CTRL_CHANGE);
+
+ if (this->options & NAND_BUSWIDTH_16)
+ offs >>= 1;
+
+ hwctrl(&mtd, offs & 0xff, NAND_CTRL_ALE | NAND_CTRL_CHANGE);
+ hwctrl(&mtd, (offs >> 8) & 0xff, NAND_CTRL_ALE);
+ hwctrl(&mtd, (page_addr & 0xff), NAND_CTRL_ALE);
+ hwctrl(&mtd, ((page_addr >> 8) & 0xff), NAND_CTRL_ALE);
+#ifdef CONFIG_SYS_NAND_5_ADDR_CYCLE
+ hwctrl(&mtd, (page_addr >> 16) & 0x0f, NAND_CTRL_ALE);
+#endif
+ hwctrl(&mtd, NAND_CMD_NONE, NAND_NCE | NAND_CTRL_CHANGE);
+
+ hwctrl(&mtd, NAND_CMD_READSTART, NAND_CTRL_CLE | NAND_CTRL_CHANGE);
+ hwctrl(&mtd, NAND_CMD_NONE, NAND_NCE | NAND_CTRL_CHANGE);
+
+ while (this->dev_ready(&mtd))
+ ;
+
+ return 0;
+}
+
+static int nand_is_bad_block(int block)
+{
+ struct nand_chip *this = mtd.priv;
+
+ nand_command(block, 0, CONFIG_SYS_NAND_BAD_BLOCK_POS, NAND_CMD_READOOB);
+
+ if (this->options & NAND_BUSWIDTH_16) {
+ if (readw(this->IO_ADDR_R) != 0xffff)
+ return 1;
+ } else {
+ if (readb(this->IO_ADDR_R) != 0xff)
+ return 1;
+ }
+
+ return 0;
+}
+
+#ifdef CONFIG_SPL_NAND_ECC
+static int nand_ecc_pos[] = CONFIG_SYS_NAND_ECCPOS;
+#define ECCSTEPS (CONFIG_SYS_NAND_PAGE_SIZE / \
+ CONFIG_SYS_NAND_ECCSIZE)
+#define ECCTOTAL (ECCSTEPS * CONFIG_SYS_NAND_ECCBYTES)
+
+static int nand_read_page(int block, int page, void *dst)
+{
+ struct nand_chip *this = mtd.priv;
+ u_char ecc_calc[ECCTOTAL];
+ u_char ecc_code[ECCTOTAL];
+ u_char oob_data[CONFIG_SYS_NAND_OOBSIZE];
+ int eccsize = CONFIG_SYS_NAND_ECCSIZE;
+ int eccbytes = CONFIG_SYS_NAND_ECCBYTES;
+ int eccsteps = ECCSTEPS;
+ int i;
+ uint8_t *p = dst;
+ nand_command(block, page, 0, NAND_CMD_READ0);
+
+ for (i = 0; eccsteps; eccsteps--, i += eccbytes, p += eccsize) {
+ if (this->ecc.mode != NAND_ECC_SOFT)
+ this->ecc.hwctl(&mtd, NAND_ECC_READ);
+ this->read_buf(&mtd, p, eccsize);
+ this->ecc.calculate(&mtd, p, &ecc_calc[i]);
+ }
+ this->read_buf(&mtd, oob_data, CONFIG_SYS_NAND_OOBSIZE);
+
+ for (i = 0; i < ECCTOTAL; i++)
+ ecc_code[i] = oob_data[nand_ecc_pos[i]];
+
+ eccsteps = ECCSTEPS;
+ p = dst;
+
+ for (i = 0; eccsteps; eccsteps--, i += eccbytes, p += eccsize)
+ this->ecc.correct(&mtd, p, &ecc_code[i], &ecc_calc[i]);
+
+ return 0;
+}
+#else
+static int nand_read_page(int block, int page, void *dst)
+{
+ struct nand_chip *this = mtd.priv;
+
+ nand_command(block, page, 0, NAND_CMD_READ0);
+ atmel_nand_pmecc_read_page(&mtd, this, dst, 0, page);
+
+ return 0;
+}
+#endif /* CONFIG_SPL_NAND_ECC */
+
+int nand_spl_load_image(uint32_t offs, unsigned int size, void *dst)
+{
+ unsigned int block, lastblock;
+ unsigned int page;
+
+ block = offs / CONFIG_SYS_NAND_BLOCK_SIZE;
+ lastblock = (offs + size - 1) / CONFIG_SYS_NAND_BLOCK_SIZE;
+ page = (offs % CONFIG_SYS_NAND_BLOCK_SIZE) / CONFIG_SYS_NAND_PAGE_SIZE;
+
+ while (block <= lastblock) {
+ if (!nand_is_bad_block(block)) {
+ while (page < CONFIG_SYS_NAND_PAGE_COUNT) {
+ nand_read_page(block, page, dst);
+ dst += CONFIG_SYS_NAND_PAGE_SIZE;
+ page++;
+ }
+
+ page = 0;
+ } else {
+ lastblock++;
+ }
+
+ block++;
+ }
+
+ return 0;
+}
+
+int at91_nand_wait_ready(struct mtd_info *mtd)
+{
+ struct nand_chip *this = mtd->priv;
+
+ udelay(this->chip_delay);
+
+ return 0;
+}
+
+int board_nand_init(struct nand_chip *nand)
+{
+ int ret = 0;
+
+ nand->ecc.mode = NAND_ECC_SOFT;
+#ifdef CONFIG_SYS_NAND_DBW_16
+ nand->options = NAND_BUSWIDTH_16;
+ nand->read_buf = nand_read_buf16;
+#else
+ nand->read_buf = nand_read_buf;
+#endif
+ nand->cmd_ctrl = at91_nand_hwcontrol;
+#ifdef CONFIG_SYS_NAND_READY_PIN
+ nand->dev_ready = at91_nand_ready;
+#else
+ nand->dev_ready = at91_nand_wait_ready;
+#endif
+ nand->chip_delay = 20;
+
+#ifdef CONFIG_ATMEL_NAND_HWECC
+#ifdef CONFIG_ATMEL_NAND_HW_PMECC
+ ret = atmel_pmecc_nand_init_params(nand, &mtd);
+#endif
+#endif
+
+ return ret;
+}
+
+void nand_init(void)
+{
+ mtd.writesize = CONFIG_SYS_NAND_PAGE_SIZE;
+ mtd.oobsize = CONFIG_SYS_NAND_OOBSIZE;
+ mtd.priv = &nand_chip;
+ nand_chip.IO_ADDR_R = (void __iomem *)CONFIG_SYS_NAND_BASE;
+ nand_chip.IO_ADDR_W = (void __iomem *)CONFIG_SYS_NAND_BASE;
+ board_nand_init(&nand_chip);
+
+#ifdef CONFIG_SPL_NAND_ECC
+ if (nand_chip.ecc.mode == NAND_ECC_SOFT) {
+ nand_chip.ecc.calculate = nand_calculate_ecc;
+ nand_chip.ecc.correct = nand_correct_data;
+ }
+#endif
+
+ if (nand_chip.select_chip)
+ nand_chip.select_chip(&mtd, 0);
+}
+
+void nand_deselect(void)
+{
+ if (nand_chip.select_chip)
+ nand_chip.select_chip(&mtd, -1);
+}
+
+#else
+
#ifndef CONFIG_SYS_NAND_BASE_LIST
#define CONFIG_SYS_NAND_BASE_LIST { CONFIG_SYS_NAND_BASE }
#endif
@@ -1227,3 +1434,4 @@ void board_nand_init(void)
dev_err(host->dev, "atmel_nand: Fail to initialize #%d chip",
i);
}
+#endif /* CONFIG_SPL_BUILD */
diff --git a/include/nand.h b/include/nand.h
index 84116f4..fc735d1 100644
--- a/include/nand.h
+++ b/include/nand.h
@@ -21,10 +21,16 @@
* at the same time, so do it here. When all drivers are
* converted, this will go away.
*/
+#ifdef CONFIG_SPL_BUILD
+#if defined(CONFIG_NAND_FSL_ELBC) || defined(CONFIG_NAND_FSL_IFC)
+#define CONFIG_SYS_NAND_SELF_INIT
+#endif
+#else
#if defined(CONFIG_NAND_FSL_ELBC) || defined(CONFIG_NAND_ATMEL)\
|| defined(CONFIG_NAND_FSL_IFC)
#define CONFIG_SYS_NAND_SELF_INIT
#endif
+#endif
extern void nand_init(void);
--
1.8.5.2
More information about the U-Boot
mailing list