[U-Boot] [PATCH v7 05/13] tegra: Convert tegra GPIO driver to use driver model

[Simon Glass]

Hi,

On 3 September 2014 17:37, Simon Glass <sjg at chromium.org> wrote:

> This is an implementation of GPIOs for Tegra that uses driver model. It has
> been tested on trimslice and also using the new iotrace feature.
>
> The implementation uses a top-level GPIO device (which has no actual
> GPIOS).
> Under this all the banks are created as separate GPIO devices.
>
> The GPIOs are named as per the Tegra datasheet/header files: A0..A7,
> B0..B7,
> ..., Z0..Z7, AA0..AA7, etc.
>
> Since driver model is not yet available before relocation, or in SPL, a
> special function is provided for seaboard's SPL code.
>
> Signed-off-by: Simon Glass <sjg at chromium.org>
>

I've tested this series as much as I can, and in particular on Tegra 20, 30
and 124. Are there any final comments before I pull it into dm/master? I'd
like to allow plenty of test time before the release.

Regards,
Simon