[U-Boot] [PATCH 23/35] arm: socfpga: board: Correctly set ATAG position

[Marek Vasut]

From: Pavel Machek <pavel at denx.de>

The bi_boot_params must point to offset 0x100 in DRAM. Make it so.

Signed-off-by: Pavel Machek <pavel at denx.de>
Signed-off-by: Marek Vasut <marex at denx.de>
Cc: Chin Liang See <clsee at altera.com>
Cc: Dinh Nguyen <dinguyen at altera.com>
Cc: Albert Aribaud <albert.u.boot at aribaud.net>
Cc: Tom Rini <trini at ti.com>
Cc: Wolfgang Denk <wd at denx.de>
Cc: Pavel Machek <pavel at denx.de>
---
 board/altera/socfpga/socfpga_cyclone5.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/board/altera/socfpga/socfpga_cyclone5.c b/board/altera/socfpga/socfpga_cyclone5.c
index fb92852..bc8a87c 100644
--- a/board/altera/socfpga/socfpga_cyclone5.c
+++ b/board/altera/socfpga/socfpga_cyclone5.c
@@ -35,5 +35,9 @@ int board_early_init_f(void)
 int board_init(void)
 {
 	icache_enable();
+
+	/* Address of boot parameters for ATAG (if ATAG is used) */
+	gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100;
+
 	return 0;
 }
-- 
2.1.0