[U-Boot] [PATCH 27/35] arm: socfpga: sysmgr: Add FPGA bits into system manager

Marek Vasut marex at denx.de
Mon Sep 15 13:06:20 CEST 2014


Add missing system manager bits from Altera U-Boot to make the code
comparable. These are the bits which depend on the FPGA manager.

Signed-off-by: Marek Vasut <marex at denx.de>
Cc: Chin Liang See <clsee at altera.com>
Cc: Dinh Nguyen <dinguyen at altera.com>
Cc: Albert Aribaud <albert.u.boot at aribaud.net>
Cc: Tom Rini <trini at ti.com>
Cc: Wolfgang Denk <wd at denx.de>
Cc: Pavel Machek <pavel at denx.de>
---
 arch/arm/cpu/armv7/socfpga/system_manager.c | 39 +++++++++++++++++++++++++++++
 1 file changed, 39 insertions(+)

diff --git a/arch/arm/cpu/armv7/socfpga/system_manager.c b/arch/arm/cpu/armv7/socfpga/system_manager.c
index 07c72e4..11f7bad 100644
--- a/arch/arm/cpu/armv7/socfpga/system_manager.c
+++ b/arch/arm/cpu/armv7/socfpga/system_manager.c
@@ -15,6 +15,43 @@ static struct socfpga_system_manager *sysmgr_regs =
 	(struct socfpga_system_manager *)SOCFPGA_SYSMGR_ADDRESS;
 
 /*
+ * Populate the value for SYSMGR.FPGAINTF.MODULE based on pinmux setting.
+ * The value is not wrote to SYSMGR.FPGAINTF.MODULE but
+ * CONFIG_SYSMGR_ISWGRP_HANDOFF.
+ */
+static void populate_sysmgr_fpgaintf_module(void)
+{
+	uint32_t handoff_val = 0;
+
+	/* ISWGRP_HANDOFF_FPGAINTF */
+	writel(0, &sysmgr_regs->iswgrp_handoff[2]);
+
+	/* Enable the signal for those HPS peripherals that use FPGA. */
+	if (readl(&sysmgr_regs->nandusefpga) == SYSMGR_FPGAINTF_USEFPGA)
+		handoff_val |= SYSMGR_FPGAINTF_NAND;
+	if (readl(&sysmgr_regs->rgmii1usefpga) == SYSMGR_FPGAINTF_USEFPGA)
+		handoff_val |= SYSMGR_FPGAINTF_EMAC1;
+	if (readl(&sysmgr_regs->sdmmcusefpga) == SYSMGR_FPGAINTF_USEFPGA)
+		handoff_val |= SYSMGR_FPGAINTF_SDMMC;
+	if (readl(&sysmgr_regs->rgmii0usefpga) == SYSMGR_FPGAINTF_USEFPGA)
+		handoff_val |= SYSMGR_FPGAINTF_EMAC0;
+	if (readl(&sysmgr_regs->spim0usefpga) == SYSMGR_FPGAINTF_USEFPGA)
+		handoff_val |= SYSMGR_FPGAINTF_SPIM0;
+	if (readl(&sysmgr_regs->spim1usefpga) == SYSMGR_FPGAINTF_USEFPGA)
+		handoff_val |= SYSMGR_FPGAINTF_SPIM1;
+
+	/* populate (not writing) the value for SYSMGR.FPGAINTF.MODULE
+	based on pinmux setting */
+	setbits_le32(&sysmgr_regs->iswgrp_handoff[2], handoff_val);
+
+	handoff_val = readl(&sysmgr_regs->iswgrp_handoff[2]);
+	if (fpgamgr_test_fpga_ready()) {
+		/* Enable the required signals only */
+		writel(handoff_val, &sysmgr_regs->fpgaintfgrp_module);
+	}
+}
+
+/*
  * Configure all the pin muxes
  */
 void sysmgr_pinmux_init(void)
@@ -26,4 +63,6 @@ void sysmgr_pinmux_init(void)
 		writel(sys_mgr_init_table[i], regs);
 		regs += sizeof(regs);
 	}
+
+	populate_sysmgr_fpgaintf_module();
 }
-- 
2.1.0



More information about the U-Boot mailing list