[U-Boot] [PATCH 43/51] arm: socfpga: pl310: Map SDRAM to 0x0

[Marek Vasut]

Configure the PL310 address filter to make sure DRAM is mapped to 0x0.
This code also configures the "remap" register of NIC-301 and sets the
required 'mpuzero' bit.

Signed-off-by: Marek Vasut <marex at denx.de>
Cc: Chin Liang See <clsee at altera.com>
Cc: Dinh Nguyen <dinguyen at altera.com>
Cc: Albert Aribaud <albert.u.boot at aribaud.net>
Cc: Tom Rini <trini at ti.com>
Cc: Wolfgang Denk <wd at denx.de>
Cc: Pavel Machek <pavel at denx.de>
---
 arch/arm/cpu/armv7/socfpga/misc.c | 14 ++++++++++++++
 1 file changed, 14 insertions(+)

diff --git a/arch/arm/cpu/armv7/socfpga/misc.c b/arch/arm/cpu/armv7/socfpga/misc.c
index 8c30b61..d3e1150 100644
--- a/arch/arm/cpu/armv7/socfpga/misc.c
+++ b/arch/arm/cpu/armv7/socfpga/misc.c
@@ -12,11 +12,17 @@
 #include <asm/arch/reset_manager.h>
 #include <asm/arch/system_manager.h>
 #include <asm/arch/dwmmc.h>
+#include <asm/arch/nic301.h>
+#include <asm/pl310.h>
 
 DECLARE_GLOBAL_DATA_PTR;
 
+static struct pl310_regs *const pl310 =
+	(struct pl310_regs *)CONFIG_SYS_PL310_BASE;
 static struct socfpga_system_manager *sysmgr_regs =
 	(struct socfpga_system_manager *)SOCFPGA_SYSMGR_ADDRESS;
+static struct nic301_registers *nic301_regs =
+	(struct nic301_registers *)SOCFPGA_L3REGS_ADDRESS;
 
 int dram_init(void)
 {
@@ -129,6 +135,14 @@ static inline void socfpga_fpga_add(void) {}
 
 int misc_init_r(void)
 {
+	/* Configure the L2 controller to make SDRAM start at 0 */
+#ifdef CONFIG_SOCFPGA_VIRTUAL_TARGET
+	writel(0x2, &nic301_regs->remap);
+#else
+	writel(0x1, &nic301_regs->remap);	/* remap.mpuzero */
+	writel(0x1, &pl310->pl310_addr_filter_start);
+#endif
+
 	/* Add device descriptor to FPGA device table */
 	socfpga_fpga_add();
 
-- 
2.0.0