[U-Boot] [PATCH] mx53loco: Disable printing cpuinfo

[Stefano Babic]

On 06/04/2015 16:23, Fabio Estevam wrote:
> Since commit 32df39c741788e ("mx5: fix get_reset_cause") we have the following
> boot messages on a mx53qsb:
> 
> U-Boot 2015.04-rc5-00029-gd68df02 (Apr 06 2015 - 11:15:39)                      
>                                                                                 
> CPU:   Freescale i.MX53 rev2.1 at 800 MHz                                       
> Reset cause: POR                                                                
> Board: MX53 LOCO                                                                
> I2C:   ready                                                                    
> DRAM:  1 GiB                                                                    
> MMC:   FSL_SDHC: 0, FSL_SDHC: 1                                                 
> In:    serial                                                                   
> Out:   serial                                                                   
> Err:   serial                                                                   
> CPU:   Freescale i.MX53 rev2.1 at 1000 MHz                                      
> Reset cause: unknown reset                                                      
> Net:   FEC [PRIME] 
> 
> The CPU and Reset cause lines appear twice.
> 
> Initially mx53 boots at 800MHz, then at a later point the PMIC is configured via
> I2C to raise the CPU voltage so that it can run at 1GHz.
> 
> To avoid such misleading double printings, disable printing cpu info for now.                                                             
> 
> Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>
> ---

Applied to u-boot-imx, thanks !

Best regards,
Stefano Babic


-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================