[U-Boot] [PATCH v2 5/8] mtd: vf610_nfc: use in-band bad block table

[Stefan Agner]

Use in-band bad block table (NAND_BBT_NO_OOB) which allows to
use the full OOB for hardare ECC purposes. Since there is no
ECC correction on the OOB it is also safer to use in-band area
to store the bad block table marker.

Signed-off-by: Stefan Agner <stefan at agner.ch>
---
 drivers/mtd/nand/vf610_nfc.c | 29 ++---------------------------
 1 file changed, 2 insertions(+), 27 deletions(-)

diff --git a/drivers/mtd/nand/vf610_nfc.c b/drivers/mtd/nand/vf610_nfc.c
index 5d72b4a..05cbdf3 100644
--- a/drivers/mtd/nand/vf610_nfc.c
+++ b/drivers/mtd/nand/vf610_nfc.c
@@ -155,29 +155,6 @@ struct vf610_nfc {
 #define mtd_to_nfc(_mtd) \
 	(struct vf610_nfc *)((struct nand_chip *)_mtd->priv)->priv
 
-static u8 bbt_pattern[] = {'B', 'b', 't', '0' };
-static u8 mirror_pattern[] = {'1', 't', 'b', 'B' };
-
-static struct nand_bbt_descr bbt_main_descr = {
-	.options = NAND_BBT_LASTBLOCK | NAND_BBT_CREATE | NAND_BBT_WRITE |
-		   NAND_BBT_2BIT | NAND_BBT_VERSION,
-	.offs =	11,
-	.len = 4,
-	.veroffs = 15,
-	.maxblocks = 4,
-	.pattern = bbt_pattern,
-};
-
-static struct nand_bbt_descr bbt_mirror_descr = {
-	.options = NAND_BBT_LASTBLOCK | NAND_BBT_CREATE | NAND_BBT_WRITE |
-		   NAND_BBT_2BIT | NAND_BBT_VERSION,
-	.offs =	11,
-	.len = 4,
-	.veroffs = 15,
-	.maxblocks = 4,
-	.pattern = mirror_pattern,
-};
-
 static struct nand_ecclayout vf610_nfc_ecc45 = {
 	.eccbytes = 45,
 	.eccpos = {19, 20, 21, 22, 23,
@@ -624,10 +601,8 @@ static int vf610_nfc_nand_init(int devnum, void __iomem *addr)
 
 	/* Bad block options. */
 	if (cfg.flash_bbt)
-		chip->bbt_options = NAND_BBT_USE_FLASH | NAND_BBT_CREATE;
-
-	chip->bbt_td = &bbt_main_descr;
-	chip->bbt_md = &bbt_mirror_descr;
+		chip->bbt_options = NAND_BBT_USE_FLASH | NAND_BBT_NO_OOB |
+				    NAND_BBT_CREATE;
 
 	/* Set configuration register. */
 	vf610_nfc_clear(mtd, NFC_FLASH_CONFIG, CONFIG_ADDR_AUTO_INCR_BIT);
-- 
2.3.5