[U-Boot] [PATCH 2/2] mx6cuboxi: Mention Cubox-i in the README

[Fabio Estevam]

Cubox-i boards are also supported, so update the README file.

Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>
---
 board/solidrun/mx6cuboxi/README | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/board/solidrun/mx6cuboxi/README b/board/solidrun/mx6cuboxi/README
index 3050c48..b417ff0 100644
--- a/board/solidrun/mx6cuboxi/README
+++ b/board/solidrun/mx6cuboxi/README
@@ -1,7 +1,7 @@
-How to use U-boot on Solid-run mx6 hummingboard
------------------------------------------------
+How to use U-boot on Solid-run mx6 Hummingboard and Cubox-i
+-----------------------------------------------------------
 
-- Build U-boot for hummingboard:
+- Build U-boot for Hummingboard/Cubox-i:
 
 $ make mrproper
 $ make mx6cuboxi_defconfig
@@ -17,5 +17,5 @@ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
 
 sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync
 
-- Insert the SD card in the hummingboard, power it up and U-boot messages
-should come up.
+- Insert the SD card in the board, power it up and U-boot messages should
+come up.
-- 
1.9.1