[U-Boot] [PATCH] Re-enable setexpr on Raspberry Pi

[Stephen Warren]

On 11/28/2015 06:56 PM, Marco Schuster wrote:
> This patch re-enables the setexpr command, I don't really understand
> why it got excluded in the first place.
> 
> setexpr can be used e.g. to implement failed-boot-counters and
> failovers to rescue firmware.
> 
> 

Two blank lines?

> Signed-off-by: Marco Schuster <m.schuster91 at googlemail.com>

This looks like a reasonable change, but

* You should CC the author of the patch that caused this issue (now CC'd)

* You should CC the person who would apply this patch (Tom Rini, now CC'd)

* You should include a Fixes: tag that specifies the commit that caused
this issue; I think:

Fixes: ef0f2f57524e ("Move defaults from config_cmd_default.h to Kconfig")

* You should double-check all the changes in the original patch in case
any other similar issues were introduced.

> ---
>  configs/rpi_2_defconfig | 1 -
>  configs/rpi_defconfig   | 1 -
>  2 files changed, 2 deletions(-)
> 
> diff --git a/configs/rpi_2_defconfig b/configs/rpi_2_defconfig
> index 5c9e69a..bd81ee6 100644
> --- a/configs/rpi_2_defconfig
> +++ b/configs/rpi_2_defconfig
> @@ -6,5 +6,4 @@ CONFIG_SYS_PROMPT="U-Boot> "
>  # CONFIG_CMD_FLASH is not set
>  # CONFIG_CMD_FPGA is not set
>  CONFIG_CMD_GPIO=y
> -# CONFIG_CMD_SETEXPR is not set
>  CONFIG_PHYS_TO_BUS=y
> diff --git a/configs/rpi_defconfig b/configs/rpi_defconfig
> index b8b267f..5d27909 100644
> --- a/configs/rpi_defconfig
> +++ b/configs/rpi_defconfig
> @@ -6,5 +6,4 @@ CONFIG_SYS_PROMPT="U-Boot> "
>  # CONFIG_CMD_FLASH is not set
>  # CONFIG_CMD_FPGA is not set
>  CONFIG_CMD_GPIO=y
> -# CONFIG_CMD_SETEXPR is not set
>  CONFIG_PHYS_TO_BUS=y