[U-Boot] [PATCH 04/10] net: axi_emac: Put iobase to private structure

[Michal Simek]

Saving iobase directly to private structure helps with moving to DM.
There is an option to load iobase from pdata but it is additional load.
Pointer to private structure is available all the time.

Signed-off-by: Michal Simek <michal.simek at xilinx.com>
---

 drivers/net/xilinx_axi_emac.c | 5 +++--
 1 file changed, 3 insertions(+), 2 deletions(-)

diff --git a/drivers/net/xilinx_axi_emac.c b/drivers/net/xilinx_axi_emac.c
index 071e0a85b582..3c980657729e 100644
--- a/drivers/net/xilinx_axi_emac.c
+++ b/drivers/net/xilinx_axi_emac.c
@@ -86,7 +86,7 @@ struct axidma_priv {
 	struct axidma_reg *dmatx;
 	struct axidma_reg *dmarx;
 	int phyaddr;
-
+	struct axi_regs *iobase;
 	struct phy_device *phydev;
 	struct mii_dev *bus;
 };
@@ -223,7 +223,7 @@ static int setup_phy(struct eth_device *dev)
 	u16 phyreg;
 	u32 i, speed, emmc_reg, ret;
 	struct axidma_priv *priv = dev->priv;
-	struct axi_regs *regs = (struct axi_regs *)dev->iobase;
+	struct axi_regs *regs = priv->iobase;
 	struct phy_device *phydev;
 
 	u32 supported = SUPPORTED_10baseT_Half |
@@ -629,6 +629,7 @@ int xilinx_axiemac_initialize(bd_t *bis, unsigned long base_addr,
 	sprintf(dev->name, "aximac.%lx", base_addr);
 
 	dev->iobase = base_addr;
+	priv->iobase = (struct axi_regs *)base_addr;
 	priv->dmatx = (struct axidma_reg *)dma_addr;
 	/* RX channel offset is 0x30 */
 	priv->dmarx = (struct axidma_reg *)(dma_addr + 0x30);
-- 
1.9.1