[U-Boot] [PATCH v2 2/3] serial: uartlite: Add support for debug console

[Michal Simek]

Add support for debug console.

Signed-off-by: Michal Simek <michal.simek at xilinx.com>
---

Changes in v2:
- Add needed header from the first patch
- Remove WATCHDOG_RESET call
- Extend commit description

 drivers/serial/Kconfig            |  7 +++++++
 drivers/serial/serial_xuartlite.c | 26 ++++++++++++++++++++++++++
 2 files changed, 33 insertions(+)

diff --git a/drivers/serial/Kconfig b/drivers/serial/Kconfig
index 1fc287ee98ec..f1e221799b81 100644
--- a/drivers/serial/Kconfig
+++ b/drivers/serial/Kconfig
@@ -92,6 +92,13 @@ config DEBUG_UART_S5P
 	  will need to provide parameters to make this work. The driver will
 	  be available until the real driver-model serial is running.
 
+config DEBUG_UART_UARTLITE
+	bool "Xilinx Uartlite"
+	help
+	  Select this to enable a debug UART using the serial_uartlite driver.
+	  You will need to provide parameters to make this work. The driver will
+	  be available until the real driver-model serial is running.
+
 config DEBUG_UART_ZYNQ
 	bool "Xilinx Zynq"
 	help
diff --git a/drivers/serial/serial_xuartlite.c b/drivers/serial/serial_xuartlite.c
index 8225d9a320a5..f42b11eae102 100644
--- a/drivers/serial/serial_xuartlite.c
+++ b/drivers/serial/serial_xuartlite.c
@@ -114,3 +114,29 @@ U_BOOT_DRIVER(serial_uartlite) = {
 	.ops	= &uartlite_serial_ops,
 	.flags = DM_FLAG_PRE_RELOC,
 };
+
+#ifdef CONFIG_DEBUG_UART_UARTLITE
+
+#include <debug_uart.h>
+
+void _debug_uart_init(void)
+{
+	struct uartlite *regs = (struct uartlite *)CONFIG_DEBUG_UART_BASE;
+
+	out_be32(&regs->control, 0);
+	out_be32(&regs->control, ULITE_CONTROL_RST_RX | ULITE_CONTROL_RST_TX);
+	in_be32(&regs->control);
+}
+
+static inline void _debug_uart_putc(int ch)
+{
+	struct uartlite *regs = (struct uartlite *)CONFIG_DEBUG_UART_BASE;
+
+	while (in_be32(&regs->status) & SR_TX_FIFO_FULL)
+		;
+
+	out_be32(&regs->tx_fifo, ch & 0xff);
+}
+
+DEBUG_UART_FUNCS
+#endif
-- 
1.9.1