[U-Boot] [PATCH] net: designware: Zap CONFIG_DW_AUTONEG

[Marek Vasut]

This symbol is not used anywhere, so remove it. For spear600, remove
it from the board file, since the symbol is not defined for spear600
either.

Signed-off-by: Marek Vasut <marex at denx.de>
Cc: Dinh Nguyen <dinguyen at opensource.altera.com>
Cc: Joe Hershberger <joe.hershberger at ni.com>
---
 board/spear/spear600/spear600.c | 3 ---
 include/configs/axs101.h        | 5 -----
 include/configs/sunxi-common.h  | 1 -
 3 files changed, 9 deletions(-)

diff --git a/board/spear/spear600/spear600.c b/board/spear/spear600/spear600.c
index fc0918f..858a9ca 100644
--- a/board/spear/spear600/spear600.c
+++ b/board/spear/spear600/spear600.c
@@ -48,9 +48,6 @@ int board_eth_init(bd_t *bis)
 
 #if defined(CONFIG_ETH_DESIGNWARE)
 	u32 interface = PHY_INTERFACE_MODE_MII;
-#if defined(CONFIG_DW_AUTONEG)
-	interface = PHY_INTERFACE_MODE_GMII;
-#endif
 	if (designware_initialize(CONFIG_SPEAR_ETHBASE, interface) >= 0)
 		ret++;
 #endif
diff --git a/include/configs/axs101.h b/include/configs/axs101.h
index 650d97d..3d6e94f 100644
--- a/include/configs/axs101.h
+++ b/include/configs/axs101.h
@@ -100,11 +100,6 @@
 #define CONFIG_PHY_GIGE
 
 /*
- * Ethernet configuration
- */
-#define CONFIG_DW_AUTONEG
-
-/*
  * Commands still not supported in Kconfig
  */
 #define CONFIG_CMD_FAT
diff --git a/include/configs/sunxi-common.h b/include/configs/sunxi-common.h
index da6ab61..d826a5b 100644
--- a/include/configs/sunxi-common.h
+++ b/include/configs/sunxi-common.h
@@ -309,7 +309,6 @@ extern int soft_i2c_gpio_scl;
 #endif
 
 #ifdef CONFIG_SUNXI_GMAC
-#define CONFIG_DW_AUTONEG
 #define CONFIG_PHY_GIGE			/* GMAC can use gigabit PHY	*/
 #define CONFIG_PHY_ADDR		1
 #define CONFIG_MII			/* MII PHY management		*/
-- 
2.1.4