[U-Boot] [PATCH 06/12] arm: socfpga: Add Altera Arria V DK support

[Pavel Machek]

On Wed 2014-12-31 20:14:54, Marek Vasut wrote:
> Add support for the Altera Arria V development kit.
> 
> Signed-off-by: Marek Vasut <marex at denx.de>
> Cc: Chin Liang See <clsee at opensource.altera.com>
> Cc: Dinh Nguyen <dinguyen at opensource.altera.com>
> Cc: Pavel Machek <pavel at denx.de>
> Cc: Stefan Roese <sr at denx.de>
> Cc: Vince Bridgers <vbridger at opensource.altera.com>
> ---
>  arch/arm/Kconfig                     |   5 +

>  board/altera/socfpga/iocsr_config.c  | 688 +++++++++++++++++++++++++++++++++++
>  board/altera/socfpga/iocsr_config.h  |   9 +
>  board/altera/socfpga/pinmux_config.c | 215 +++++++++++

These are normally autogenerated, how does that work?

>  board/altera/socfpga/socfpga.c       |   7 +
>  configs/socfpga_arria5_defconfig     |   3 +
>  include/configs/socfpga_arria5.h     | 107 ++++++

These look better. Can more defines be moved to common socfpga.h.

Thanks,
							Pavel

> diff --git a/include/configs/socfpga_arria5.h b/include/configs/socfpga_arria5.h
> new file mode 100644
> index 0000000..668a91e
> --- /dev/null
> +++ b/include/configs/socfpga_arria5.h
> @@ -0,0 +1,107 @@
> +/*
> + * Copyright (C) 2014 Marek Vasut <marex at denx.de>
> + *
> + * SPDX-License-Identifier:	GPL-2.0+
> + */
> +#ifndef __CONFIG_SOCFPGA_ARRIA5_H__
> +#define __CONFIG_SOCFPGA_ARRIA5_H__
> +
> +#include <asm/arch/socfpga_base_addrs.h>
> +#include "../../board/altera/socfpga/pinmux_config.h"
> +#include "../../board/altera/socfpga/iocsr_config.h"
> +#include "../../board/altera/socfpga/pll_config.h"
> +
> +/* U-Boot Commands */
> +#define CONFIG_SYS_NO_FLASH
> +#include <config_cmd_default.h>
> +#define CONFIG_DOS_PARTITION
> +#define CONFIG_FAT_WRITE
> +#define CONFIG_HW_WATCHDOG
> +
> +#define CONFIG_CMD_ASKENV
> +#define CONFIG_CMD_BOOTZ
> +#define CONFIG_CMD_CACHE
> +#define CONFIG_CMD_DFU
> +#define CONFIG_CMD_DHCP
> +#define CONFIG_CMD_EXT4
> +#define CONFIG_CMD_EXT4_WRITE
> +#define CONFIG_CMD_FAT
> +#define CONFIG_CMD_FPGA
> +#define CONFIG_CMD_FS_GENERIC
> +#define CONFIG_CMD_GREPENV
> +#define CONFIG_CMD_MII
> +#define CONFIG_CMD_MMC
> +#define CONFIG_CMD_NET
> +#define CONFIG_CMD_PING
> +#define CONFIG_CMD_SETEXPR
> +#define CONFIG_CMD_USB
> +#define CONFIG_CMD_USB_MASS_STORAGE
> +
> +#define CONFIG_REGEX			/* Enable regular expression support */
> +
> +/* Memory configurations */
> +#define PHYS_SDRAM_1_SIZE		0x40000000	/* 1GiB on SoCDK */
> +
> +/* Booting Linux */
> +#define CONFIG_BOOTDELAY	3
> +#define CONFIG_BOOTFILE		"zImage"
> +#define CONFIG_BOOTARGS		"console=ttyS0," __stringify(CONFIG_BAUDRATE)
> +#ifdef CONFIG_SOCFPGA_VIRTUAL_TARGET
> +#define CONFIG_BOOTCOMMAND	"run ramboot"
> +#else
> +#define CONFIG_BOOTCOMMAND	"run mmcload; run mmcboot"
> +#endif
> +#define CONFIG_LOADADDR		0x8000
> +#define CONFIG_SYS_LOAD_ADDR	CONFIG_LOADADDR
> +
> +/* Ethernet on SoC (EMAC) */
> +#if defined(CONFIG_CMD_NET)
> +#define CONFIG_EMAC_BASE		SOCFPGA_EMAC1_ADDRESS
> +#define CONFIG_PHY_INTERFACE_MODE	PHY_INTERFACE_MODE_RGMII
> +
> +/* PHY */
> +#define CONFIG_PHY_MICREL
> +#define CONFIG_PHY_MICREL_KSZ9021
> +#define CONFIG_KSZ9021_CLK_SKEW_ENV	"micrel-ksz9021-clk-skew"
> +#define CONFIG_KSZ9021_CLK_SKEW_VAL	0xf0f0
> +#define CONFIG_KSZ9021_DATA_SKEW_ENV	"micrel-ksz9021-data-skew"
> +#define CONFIG_KSZ9021_DATA_SKEW_VAL	0x0
> +
> +#endif
> +
> +/* USB */
> +#ifdef CONFIG_CMD_USB
> +#define CONFIG_USB_DWC2_REG_ADDR	SOCFPGA_USB1_ADDRESS
> +#endif
> +#define CONFIG_G_DNL_MANUFACTURER      "Altera"
> +
> +/* Extra Environment */
> +#define CONFIG_HOSTNAME		socfpga_arria5
> +
> +#define CONFIG_EXTRA_ENV_SETTINGS \
> +	"verify=n\0" \
> +	"loadaddr= " __stringify(CONFIG_SYS_LOAD_ADDR) "\0" \
> +	"ramboot=setenv bootargs " CONFIG_BOOTARGS ";" \
> +		"bootm ${loadaddr} - ${fdt_addr}\0" \
> +	"bootimage=zImage\0" \
> +	"fdt_addr=100\0" \
> +	"fdtimage=socfpga.dtb\0" \
> +		"fsloadcmd=ext2load\0" \
> +	"bootm ${loadaddr} - ${fdt_addr}\0" \
> +	"mmcroot=/dev/mmcblk0p2\0" \
> +	"mmcboot=setenv bootargs " CONFIG_BOOTARGS \
> +		" root=${mmcroot} rw rootwait;" \
> +		"bootz ${loadaddr} - ${fdt_addr}\0" \
> +	"mmcload=mmc rescan;" \
> +		"load mmc 0:1 ${loadaddr} ${bootimage};" \
> +		"load mmc 0:1 ${fdt_addr} ${fdtimage}\0" \
> +	"qspiroot=/dev/mtdblock0\0" \
> +	"qspirootfstype=jffs2\0" \
> +	"qspiboot=setenv bootargs " CONFIG_BOOTARGS \
> +		" root=${qspiroot} rw rootfstype=${qspirootfstype};"\
> +		"bootm ${loadaddr} - ${fdt_addr}\0"
> +
> +/* The rest of the configuration is shared */
> +#include <configs/socfpga_common.h>
> +
> +#endif	/* __CONFIG_SOCFPGA_ARRIA5_H__ */

-- 
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html