[U-Boot] [PATCH v4 0/3] pmic:pfuze support buck regulator mode switch

Peng Fan Peng.Fan at freescale.com
Fri Jan 16 17:05:11 CET 2015


Hi, Przemyslaw

There is a few return value comments that from Fabio, I correct them and
send out v4 version. Others are same to the v1 version patch set. If
this patch set is fine, please give you Acked-by. Sorry for the troubles.

This patch set is to support buck regulator can
working in different switching modes. To improve
system efficiency the buck regulators can operate
in different switching modes.

patch 1/3 is to add related bit definitions and registers.
patch 2/3 is to implement the switching mode init function.
patch 3/3 is to add related mode init function in board code.

mx6slevk board is not included in this patch set, since power
and i2c interface are not implemented for it. Future patch will
cover this to add PAD setting, power_init_board and etc.


Peng Fan (3):
  pmic:pfuz100 add switch mode and more registers
  pmic:pfuze implement pmic_mode_init
  imx:mx6 set normal APS and standby PFM mode

 board/freescale/common/pfuze.c                | 36 ++++++++++++++++++
 board/freescale/common/pfuze.h                |  1 +
 board/freescale/mx6qsabreauto/mx6qsabreauto.c |  6 +++
 board/freescale/mx6sabresd/mx6sabresd.c       |  6 ++-
 board/freescale/mx6sxsabresd/mx6sxsabresd.c   |  6 ++-
 include/power/pfuze100_pmic.h                 | 53 +++++++++++++++++++++++++++
 6 files changed, 106 insertions(+), 2 deletions(-)

-- 
1.8.4




More information about the U-Boot mailing list